It would jump better if you positioned your wing right

it looked fine to me?

Too far back but I will quit now as this has been documented about a billion times

no joke

I have had this buggy a week and a half..
Any tips would be helpfull to me, so on that note.. What do you meen right?
It jumps awesome and do not need to use gas or brake to correct in a jump.
But, like i said.. Any tips are welcome..

ok i see it now

Do i correct this by using the three hole adjustment on the wing mount?

The gap between the front edge of the wing and the rear shock tower should be about 28mm. move the wing where the rear holes on the wing are screwed to the front 2 holes of the wing mount. Use only 2 screws

There is even a mod people are using now with a much shorter wing mount and supposed to be tons better too.

Ahh , ok... Thanks..

I am running all 4 screws in the wing and it seems good

Ive seen the wing mod with the kyosho wing, is that what you guys are talking about?

TOO MANY PAGES!!! Can someone point me to the page where it shows someone soldered on battery connectors on a Tekin RS? It was a great idea and I wanted see the pic...

Thanks in advance!

Not really. I highly recommend everyone reading the nitro rc8b forum. You will find the majority of tuning tips there.

I have the team associated conversion with the mmm 2200 kv combo.
I have never ran 1/8 buggy before this year planned to before just never had the time. I have always ran 1/10 buggy and 4x4 sct.

I got the rc8 maybe a year and half ago with full intentions to get into 1/8 buggy but didnt get to. I just wonder if i am going to be at a total disadvantage with it compared to the newer kits out now. Thanks for the reply any info is better than none.

Hmm, probably the wrong place for the RS. Most run MMM or RX8s.

Here is a video from Tekin on wiring the RX8.

+ YouTube Video

Otherwise you might want to try a 1/10 scale thread.

j