New Tekin SC4X Motors
#365
Yup, I ran mine on a track about 12,000 sq ft and was coming off after a 8 minute main at 165 all day long. It was about 90 degrees out. I was running an 17t on my Ofna Hyper 10 and I think it could have pulled more!
#367
#368
I'm fine with 165. It was a huge 1/8 track and we were getting after it for 8 minutes. I has one of if the the fastest trucks on the track and I was trying to push the motor. I'm sure I didn't need the 17t but it was fast!
#370
Let my buddy run my SC4X 4.5 tonight since I couldn't make it to the track. No difference in speed, torque, temps, or runtime over the Novak 4.5 550 is what he reported. Felt exactly the same in all regards. Disappointing........I was expecting a little bit more of SOMETHING
At least it has a better front bearing..... I could have saved 75$ though just buying one for the novak
At least it has a better front bearing..... I could have saved 75$ though just buying one for the novak
#372
We all run MMP's. Smoothness is not an issue we ever had with the Novaks, they are plenty smooth IMO.
#374
I've been running a Slash 4x4 since last winter till now. The set-up is a MMP with another brand 4.5 brushless motor running on a two cell lipo. I’m also running the MMP with zero timing at start with a little ramp of timing on top with a 14/54 gearing. Also nothing is turned down in the way of power limiting. This set-up I always run has very smooth power, lots of torque, and excellent speed. After running the Tekin on the MMP with the same set up as my older motor. I decided to let another excellent driver run my old 4.5 with my old set up on his Slash 4x4. This was going to be a good test to see the true difference between the two. He ended up running me pretty hard all day long. But he had to leave before the main event giving me the motor back. To see the true difference after running the Tekin 4.5 all day long I put the old 4.5 motor back in for the main event. From what I felt the Tekin wasn't as smooth, responsive, or fast as the old unit which lap times also showed. At this point I wasn't very excited other than having a cool red looking motor. The Tekin was running about a 140 to 150 all day long with no problems but just didn't have the torque, speed, or the biggest thing smoothness of my older unit. I will try some other things with it the next time out. This is just what I’ve found out at this point in time. I've not had any problems with any of Tekin RX8's (new cases) or 1900 and 2050 Tekin 8th scale motors. At this point the service or quality of the Tekin stuff has been top notch in my book.
#375
Nice TEKIN, glad to see these motors are SOOOO "WORTH THE WAIT". So much for being a man of your word there TekinPrez Where do I send this motor to get my FULL refund?