HPI Cup Racer 1M
#1652
what gear ratio should i use with my brushless motor its 6800kv?
THanks Pyro
THanks Pyro
#1653
Tech Initiate
Picked up my RSR CR last week, Also got the brake disk kit, alu. steering turn buckle, sway bar kit, drift tires.
This Thing is a BLAST!!!
Have a Tekin 13.5 RS combo in it, on a 2s lipo, and this lil sucker gets it.
When the turbo boost hits, its gone.
Altho, the Alu. axle cups from HR are a must.
Ill post better pics up tomorrow.
Cell phone pic..
This Thing is a BLAST!!!
Have a Tekin 13.5 RS combo in it, on a 2s lipo, and this lil sucker gets it.
When the turbo boost hits, its gone.
Altho, the Alu. axle cups from HR are a must.
Ill post better pics up tomorrow.
Cell phone pic..
#1655
Picked up my RSR CR last week, Also got the brake disk kit, alu. steering turn buckle, sway bar kit, drift tires.
This Thing is a BLAST!!!
Have a Tekin 13.5 RS combo in it, on a 2s lipo, and this lil sucker gets it.
When the turbo boost hits, its gone.
Altho, the Alu. axle cups from HR are a must.
Ill post better pics up tomorrow. If you can get your hands on them, ditto on the HR axle cups.
Cell phone pic..
This Thing is a BLAST!!!
Have a Tekin 13.5 RS combo in it, on a 2s lipo, and this lil sucker gets it.
When the turbo boost hits, its gone.
Altho, the Alu. axle cups from HR are a must.
Ill post better pics up tomorrow. If you can get your hands on them, ditto on the HR axle cups.
Cell phone pic..
#1656
Tech Initiate
Snaped a few more pics, Some are blurry but didnt have a lot of time this morning when i took um.
#1658
Tech Initiate
#1660
Tech Adept
Hi guys,
Just few words to show you that HPI is working on a potential evolution of the current Cup Racer. I prefer to be clear once again: these pictures below only show a car project only (Atsushi Hara prototype actually), not a production kit.
Final Design/production/release date are to be decided, so just enjoy things as they are now !
Just few words to show you that HPI is working on a potential evolution of the current Cup Racer. I prefer to be clear once again: these pictures below only show a car project only (Atsushi Hara prototype actually), not a production kit.
Final Design/production/release date are to be decided, so just enjoy things as they are now !
#1661
Tech Adept
to finish...
#1662
I always wondered when somebody would start making carbon/graphite knuckles. Looks nice, I guess we'll have to say bye bye to inboard shocks. Thanks for sharing.
#1665
where do you get the aluminum ones at?