23T motor thread
#1010
Tech Champion
iTrader: (31)
Originally Posted by work
Dave
Any idea how the Kawada compares to the other 23T? Especially the Vxr?
Any idea how the Kawada compares to the other 23T? Especially the Vxr?
-Dave
#1011
Guest
Originally Posted by JDM_DOHC_SiR
5.3??? ..maybe 5.5
-Dave
-Dave
#1012
Guest
Originally Posted by canto54
Thanks, I also have a Yok Tmax FSR, which one should I use and how to gear the FSR on the same track?
I'm a new uer aof these motor. For the 1st test I do, I find them very impressive and my friends can't believe I was running 23T...
I'm a new uer aof these motor. For the 1st test I do, I find them very impressive and my friends can't believe I was running 23T...
#1014
Tech Adept
Originally Posted by JDM_DOHC_SiR
5.3??? ..maybe 5.5
-Dave
-Dave
#1015
Stock motors
Hi Guys,
Anyone running HPI R2 motors?
Any commend?
Which is better? Standup or laydown brushes?
Does it really affect the performance?
Anyone running HPI R2 motors?
Any commend?
Which is better? Standup or laydown brushes?
Does it really affect the performance?
#1016
DAVE: hey there! i just got a new Kawada VS.. i understand from your post that this motor is high rpm, i used to run a Katana ss that i geared with a 5.52 ratio at a local track... any suggestions for the kawada vs? also, i have a new Alex RD flat-out would you know of this motor too? my track has a 45-meter back straight and is not so technical hope you could help thanks!
Carlo
Carlo
#1017
Just got a new motor, Orion SV2 23x2T 25000rpm. Was this high rpm or high torque? start with 5.5 or something else?
#1018
Tamiya RZ rpms
hey guys
i tryed a new spring and brush combo on my Tamiya RZ last night.. and the results surprised me a litte
std springs, std brushes (seratted though) pulled 29000 revs
std springs, fantom 315 brushes brand new pulled 25-26000 rpm
trinity purple pos, trinity red neg, fantom 315's pulled 25000rpm
are these numbers good for a 23T stock motor or is this motor past its prime??? i have no idea what to expect having only raced 540 before.
thanks
i tryed a new spring and brush combo on my Tamiya RZ last night.. and the results surprised me a litte
std springs, std brushes (seratted though) pulled 29000 revs
std springs, fantom 315 brushes brand new pulled 25-26000 rpm
trinity purple pos, trinity red neg, fantom 315's pulled 25000rpm
are these numbers good for a 23T stock motor or is this motor past its prime??? i have no idea what to expect having only raced 540 before.
thanks
#1020
Tech Master
iTrader: (3)
Originally Posted by diha
Hi Guys,
Anyone running HPI R2 motors?
Any commend?
Which is better? Standup or laydown brushes?
Does it really affect the performance?
Anyone running HPI R2 motors?
Any commend?
Which is better? Standup or laydown brushes?
Does it really affect the performance?