TLR 22 3.0 Race Kit Thread!
|
|||
#3166
Tech Regular
iTrader: (4)
But on the B6 thread they are whining about it apparently being available already in Japan and not here. There's always something to complain about!
I've convinced myself that I don't need the laydown until I'm pushing hard enough that the buggy is holding me back. I'm not that good yet! Maybe a 4.0 will be out by the time that happens... then maybe the rage will be front-motor with belt drive to the back or something!
I've convinced myself that I don't need the laydown until I'm pushing hard enough that the buggy is holding me back. I'm not that good yet! Maybe a 4.0 will be out by the time that happens... then maybe the rage will be front-motor with belt drive to the back or something!
#3169
One question: on the setup sheets, I see you're running the kick shim under the pivot. Why not just run the HRC pivot?
#3170
R/C Tech Elite Member
iTrader: (112)
But on the B6 thread they are whining about it apparently being available already in Japan and not here. There's always something to complain about!
I've convinced myself that I don't need the laydown until I'm pushing hard enough that the buggy is holding me back. I'm not that good yet! Maybe a 4.0 will be out by the time that happens... then maybe the rage will be front-motor with belt drive to the back or something!
I've convinced myself that I don't need the laydown until I'm pushing hard enough that the buggy is holding me back. I'm not that good yet! Maybe a 4.0 will be out by the time that happens... then maybe the rage will be front-motor with belt drive to the back or something!
#3173
Tech Initiate
Found this also but lucky I had some shorter studs in my box. A slight over sight by the team who designed the final conversion kit.