tiko

iTrader: (35)

Thanks I'll look in to that, and how soon do you think that new charger is doing to be available?

b_mcduffie

iTrader: (16)

we are hearing at the end of march.... but thats a maybe.. waiting to hear back from pillars. let you know

tiko

iTrader: (35)

Sound good keep us posted.

xtrememadness

iTrader: (2)

hey guys i was reading the setup on ryan cavalieri orion motor and it says -3 lines on timing. how much timing is this. thanx

STLNLST

iTrader: (32)

18 degrees. Each line is 6 degrees.

xtrememadness

iTrader: (2)

thanx stlnlst. now is this clockwise or counter clockwise from center. i only ask because it says -3 lines like that would be negative. asuming the center line is 0 degrees. thanx again

STLNLST

iTrader: (32)

It would be counter clockwise. I also assume the center line is 0 degrees and I move the slash mark towards the right of the "0" mark to increase timing. I hope this helps you in what you're trying to do. I'll be trying 0 degrees of timing along with the new settings I was given for the Orion speed control. I'll let you know how that goes after the weekend.

johnnyboy

iTrader: (28)

I was told by Pillars that each line is 4 degrees

the "-3" that most of us are running is turning the endbell clockwise (retarding the timing). It will depend on the timing setting in the ESC as well...

STLNLST

iTrader: (32)

He told me 6

johnnyboy

iTrader: (28)

Now that I think about it, my conversation with him was an older one in regards to the 2008 Race V1, perhaps a little different on the V2's?

xtrememadness

iTrader: (2)

tanx for the help guys. i race the 13.5 and 17.5 v1 motors in onroad with great success at 0 timing .but im gonna do a little 2wd buggy with a 7.5 v2 motor in offroad. i have the tekin rs with version 189 with the boost timing so i want to make sure i dont kill the motor i know the settings for ryans lrp so i will try to duplicate that. i will let you know how that goes

STLNLST

iTrader: (32)

From what I've seen of the Tekin speedo you may want to run O timing on the motor and max boost. This is with the 13.5/10.5 motors though.

xtrememadness

iTrader: (2)

yeah thats what i run but thats more for 17.5 1/12th scale. : i know tekin runs the 13.5 and 10.5 at 24 degrees on the motor and like 12 on the boost but this is with tekin motors. i dont know what i would set the orion 7.5 at

STLNLST

iTrader: (32)

I'm not too sure what to set it at either. I have only run the Orion 13.5. Maybe try going on the Tekin thread and ask what they run their 7.5 motors at and then try the same on the Orion. Once you get a good setting with the 7.5 please share with the rest of us Good luck and happy racing.

xtrememadness

iTrader: (2)

ok i will post on tekin and let you know