Ask Aaron Waldron
05-05-2005, 12:36 PM
#2373
Tech Regular
AW
Great job at the nationals, you still out their in cyberspace???
Great job at the nationals, you still out their in cyberspace???
05-05-2005, 08:00 PM
#2374
Team Waldron laid it down at the nats, good job to you and your dad.
05-05-2005, 08:03 PM
#2375
Aaron, got a question for ya. Ran the AD2 for the first time this week, and I noticed that the motor takes a while to get back down to idle speed when you let off the gas. The idle is correct because after a couple seconds it slows back down to a slow "loping" idle. I played with the bottom end (richening) but the truck then got sluggish, any recommendations off hand?
It also seems like the motor has to rev up a bit before the truck will begin to move, and it jumps forward rather than creeping forward. What is the best thing to do to the clutch to make it feel more like an ESC
. Thanks.
B
It also seems like the motor has to rev up a bit before the truck will begin to move, and it jumps forward rather than creeping forward. What is the best thing to do to the clutch to make it feel more like an ESC
. Thanks.B
05-06-2005, 06:59 AM
#2378
also make sure the throttle arm/lever is not binding.
05-06-2005, 02:03 PM
#2380
Tech Rookie
if the motor takes a while to return to idle it could mean the carb is not sealed. I just learned about this, as its been giving me tuning problems and the idle is one of the tell tale symptoms
05-06-2005, 02:30 PM
#2381
Waldron-what kind of hair gel do you use to get your hair like that?.....what up braaaaaaaaaaaaaaaaahhhhhhhhhh?!
05-08-2005, 10:51 PM
#2383
Originally posted by Brandon Melton
I noticed that the motor takes a while to get back down to idle speed when you let off the gas
[/B]
I noticed that the motor takes a while to get back down to idle speed when you let off the gas
[/B]
05-10-2005, 04:35 PM
#2384
Tech Rookie
whats better?
whats better the engine that comes with the rc10gtplus or a o.s. .12 cvr-x engine?
thnaks
thnaks