Serpent Spyder SRX-2 Mid Motor Buggy Thread
#1802
Tech Regular
#1803
#1804
anyone know what spacers are used behind a savok servo?
#1805
#1806
can someone please help trying to get my build done need to know what spacers to use for savok servo? please
#1807
Tech Addict
#1808
#1809
anyone know which inserts go in the transmission case for billys spectrum setup?
#1811
Just received my Spyder SRX-2 MM. Started the build. Based on what I read before, I purchased some nut drivers tool kit. (4, 5, 5.5, 7mm)
Looks like the 4 is too small and the 5 is too large for steps 11 and 12.
I am stuck here without proper tools. Are these the proper tools?
Looks like I would need a 4.5mm instead? Can anyone tell me which tools I need?
Looks like the 4 is too small and the 5 is too large for steps 11 and 12.
I am stuck here without proper tools. Are these the proper tools?
Looks like I would need a 4.5mm instead? Can anyone tell me which tools I need?
#1812
Tech Regular
Just received my Spyder SRX-2 MM. Started the build. Based on what I read before, I purchased some nut drivers tool kit. (4, 5, 5.5, 7mm)
Looks like the 4 is too small and the 5 is too large for steps 11 and 12.
I am stuck here without proper tools. Are these the proper tools?
Looks like I would need a 4.5mm instead? Can anyone tell me which tools I need?
Looks like the 4 is too small and the 5 is too large for steps 11 and 12.
I am stuck here without proper tools. Are these the proper tools?
Looks like I would need a 4.5mm instead? Can anyone tell me which tools I need?
#1814
Tech Elite
iTrader: (57)
Just received my Spyder SRX-2 MM. Started the build. Based on what I read before, I purchased some nut drivers tool kit. (4, 5, 5.5, 7mm)
Looks like the 4 is too small and the 5 is too large for steps 11 and 12.
I am stuck here without proper tools. Are these the proper tools?
Looks like I would need a 4.5mm instead? Can anyone tell me which tools I need?
Looks like the 4 is too small and the 5 is too large for steps 11 and 12.
I am stuck here without proper tools. Are these the proper tools?
Looks like I would need a 4.5mm instead? Can anyone tell me which tools I need?
1.5/2.0/2.5mm Hex wrenches
4/4.5/5/5.5/7mm Hex nut drivers
3mm turnbuckle wrench
#1815