HB Racing D418 - 1/10 4WD Buggy
#391
Tech Champion
iTrader: (45)
Anyone cut the outside holes of your towers off so the have a less chance to break. I have seen the rear towers break and the front towers are so wide its only a matter if time. Most every set up I have seen no one uses the outter two holes on both towers. Recent picture of David's car looks like he has done this on the towers he is running.
#392
Tech Master
iTrader: (36)
Anyone cut the outside holes of your towers off so the have a less chance to break. I have seen the rear towers break and the front towers are so wide its only a matter if time. Most every set up I have seen no one uses the outter two holes on both towers. Recent picture of David's car looks like he has done this on the towers he is running.
#393
Tech Initiate
Had earlier Hobbywing G3 V10 6.5T motor in my D418 and it even on slippery tracks required 10degree boost timing to go fast enough. Now new 5.5t orion ultimate mod goes better even without boost. Cannot wait to test this motor on our outdoor astroturf track in next month.
So smooth and so much power. 23/70 gearing on 6.5t and 21/70 gearing on 5.5t both with slipper.
So smooth and so much power. 23/70 gearing on 6.5t and 21/70 gearing on 5.5t both with slipper.
#395
#397
Tech Regular
13.5 modifications
Does anyone know if there are any plastic gears that fit in the diffs? I know HB has made them for the Pro 5 and TCXX, just unsure if they will fit.
#398
Tech Initiate
Heres my fine tuned astroturf setup for D418. Easy to drive and fast.
Last edited by rcuser456734567; 04-24-2019 at 02:51 AM.
#399
Tech Rookie
Hinge pin mounts
I did a quick search but I couldn't find an explanation for the hinge pin mount options. I see on the setup sheets that the same degree of kickup can show up multiple times with the different combinations. Can someone explain why I would use two of the one dot carriers vs two of the three dot carriers? Both would get me 10 degrees of kickup correct?
#400
Tech Initiate
I did a quick search but I couldn't find an explanation for the hinge pin mount options. I see on the setup sheets that the same degree of kickup can show up multiple times with the different combinations. Can someone explain why I would use two of the one dot carriers vs two of the three dot carriers? Both would get me 10 degrees of kickup correct?
#401
Tech Adept
#402
I’m going to have to look into this at some point down the road, I love my D413, tougher than nails, this looks a little longer maybe and a little bit lower center of gravity.
#403
Tech Initiate
#404
Tech Adept
#405
Tech Rookie
Air Ration shock set up
Does anyone know what type of shock cap bladder option called ‘Air Ration’ are ?