Steve Weiss

Well, we really don't recommend trying to shorten those wires on your own...

But I have seen people cut sections out of the middle and solder/shrink wrap them to get them to the length they want.

STLNLST

iTrader: (32)

Steve- You and the crew going to the big club race in seattle in July? You get trophies and a national title if you win....ha ha ha ha

Guo Chean

iTrader: (4)

Steve - if we runing regular brush Co27 on medium track with a FDR 6.75 what FDR should we run on 13.5R? thanks

Steve Weiss

Most people have been running their sintered 13.5's around 4.5-5.0

TJ Bradley

straw hat?

Steve Weiss

Damn straight!

I'm still waiting for that thing!

How are things baby blue?

CSF0623

iTrader: (12)

How's about gearing on a 10.5? Thanks Carl

Steve Weiss

10.5 Pro gearing: 5.5FDR for most applications...sometimes a bit taller...sometimes lower.

Victor Vector

iTrader: (9)

And on roll out for 10.5 1/12th scale please.

Does ya gotta nansa for me ?

Jacko

Hebiki

iTrader: (26)

found it

CSF0623

iTrader: (12)

Thank Weiss one! See you at BCR.

Branden Moody

iTrader: (8)

Steve I own a Novak GTX and was at the track the other day and I came to a complete stop to check some thing and when I was done I pulled the throttle and it wouldnt move and eve the stering didnt work. So I pulled it off the track and every thing was fine no wires undone or bars unsoledered then I flip the swich off then on and a small pop and a little smoke came from the negative end of the curicut board and it worked fine I took it out that night and put all new wire on it and nothing was touching that shouldnt have. Nothing else happend and it still words fine but I herd that one of the fets could have blown out. I was wondering what could have happened.

Steve Weiss

Yeah, something definately could have let go, if not a transistor than an internal schottky diode.

Are you running an external schottky on the motor and is your power cap in good condition?

trilerian

iTrader: (51)

Hello, my gtb has started having issues. When I hit the accelerator (trigger) it stutters quite a lot. Sometimes it doesn't go full speed either. I referenced the troubleshooting section of the manual, which the suggestion is wiring, or the capacitor. The wiring is good, however how do I tell if a cap is bad. It looks fine, no burnt smell, is intact. And it has only had a 13.5 on it for the last couple of months.

GCracker

iTrader: (6)

STEVE,

QQ is Novak likely to be packaging the GTB 1711 and 13.5SS motor any time in the future. Considering a purchase in the near future but dont want to jump if something is in the works.

Thanks