VBC new 1/10 touring car, Wildfire.
#1096
Vta Wheel
For the front you'll need the HPI 0 off set and for the rear the +6mm. I put a 1mm hex shim to give the proper clearance.
#1097
#1098
Tech Initiate
#1100
Tech Elite
iTrader: (21)
I have sat and talked with Dave quite a bit lately about the VBC cars and I am very impressed.
Touring cas are all starting to look like clone after clone and the VBC cars are unique, and they really do work well from what I have seen.
Hoping to run one this season
#1103
Just wondering if the do6 will come with the red anodized parts like in the pics? Or are they just prototype pieces???
#1105
Tech Adept
Hi guys, I have one question: does someone use a midflex or flex chassis on the original wildfire? I'm running on low grip asphalt and need overall more grip. The balance is quite very well it's just for the general grip niveau.
Thanks in advance
Thanks in advance
#1106
Just seen this on VBC facebook far left is a pic of the ghost
#1107
Wow it's alive!!!!!!
#1108
I sometimes just run mine with just the 4 screws in the rear of the top deck for more flex.
Last edited by Potoczak; 08-02-2013 at 07:21 PM.
#1109
I have been running two out of the front and four in the rear and it was a night and day change