Thunder Power RC Z3R Motors
#76
#77
Tech Adept
Has anyone got a speedo and motor setup for a z3r 13.5 using a sp/hw speedo in the open timing class? It's an indoor track measuring 36mx22m not looking for anything definitive just a starting point
#79
is this motor suitable for 10.5t boosted class? the temperature around my track is about 36 celcius, and compare to the x12, which one run cooler and smoother?
#82
#83
Tech Master
iTrader: (6)
Hi All,
I swapped a 13.5 stator from my 17.5 to test for TCS and it was cogging bad. Sure enough no sensor signals (confirmed with a checker). Switch to a different motor and all is well.
Any particular precautions one should take when doing stator swaps in these motors? Have done many sensor board swaps / rotor swaps in other motors without any issues.
Thanks,
Jimmy
I swapped a 13.5 stator from my 17.5 to test for TCS and it was cogging bad. Sure enough no sensor signals (confirmed with a checker). Switch to a different motor and all is well.
Any particular precautions one should take when doing stator swaps in these motors? Have done many sensor board swaps / rotor swaps in other motors without any issues.
Thanks,
Jimmy
#84
Tech Regular
iTrader: (1)
Hi All,
I swapped a 13.5 stator from my 17.5 to test for TCS and it was cogging bad. Sure enough no sensor signals (confirmed with a checker). Switch to a different motor and all is well.
Any particular precautions one should take when doing stator swaps in these motors? Have done many sensor board swaps / rotor swaps in other motors without any issues.
Thanks,
Jimmy
I swapped a 13.5 stator from my 17.5 to test for TCS and it was cogging bad. Sure enough no sensor signals (confirmed with a checker). Switch to a different motor and all is well.
Any particular precautions one should take when doing stator swaps in these motors? Have done many sensor board swaps / rotor swaps in other motors without any issues.
Thanks,
Jimmy
#86
The Reedy's & TP's seem to run very cool compared with others. just don't let that make you think you can just ramp everything up to max!
#87
Tech Adept
I agree with you. I use TP 4.5T boosted, the temp was 65deg the max and it was smooth and fast
Last edited by minez; 02-03-2012 at 08:07 PM.
#88
#90
WOW thanks now it sounds a bit more lively hahaha