Losi 8ight building and setup
#3316
Hey Guy's, great pic's! I hope you guy's have a practice body,so you dont scratch up that pretty paint! Keep the pic's coming!!
#3318
Tech Regular
iTrader: (7)
Originally Posted by cornerspeed
How often have you guys had to replace your brake disc's due to them getting the hole hogged out around the outdrives? Mine are pretty sloppy. Probably should have replaced them a while ago on my ride.
#3319
Tech Fanatic
iTrader: (1)
Originally Posted by turtletrax
Im having that problem on my 8T. less than a gallon and already went through 2 rear discs(spun on outdrive) Im not buying a 3rd Im gonna try somethin else
Didn't I hear that the brake linkages were set completely wrong on the rolling chassis and that you (the buyer) were supposed to correct them before use? I believe I've heard of worse things than just busting discs from not correcting this before driving. I think someone stripped teeth on their clutch and spur gears because of it.
#3320
Tech Fanatic
iTrader: (1)
Originally Posted by turtletrax
Im having that problem on my 8T. less than a gallon and already went through 2 rear discs(spun on outdrive) Im not buying a 3rd Im gonna try somethin else
8ight T Throttle/Brake Addendum
#3322
Tech Regular
Here are mine from rcpro round one north.
#3323
Bro that paint scheme is AWSOME!!!!!!
#3324
Tech Regular
Thanks, my buddy Steve Christian did the paint .He was tired of my rattle can paint.LOL I finished fourth in truggy and was running third in buggy when I broke.
#3325
Tech Adept
could someone post a pic of what the aluminum clutches look like when
theyre shot mine look like the clutch bell took a grinder to em i have the RTR
version and wanted to add the composite clutches when i noticed this
theyre shot mine look like the clutch bell took a grinder to em i have the RTR
version and wanted to add the composite clutches when i noticed this
#3326
Tech Champion
iTrader: (7)
Originally Posted by indaway
Thanks, my buddy Steve Christian did the paint .He was tired of my rattle can paint.LOL I finished fourth in truggy and was running third in buggy when I broke.
OK, on to my 8. Last night, some friends thought I had the front green springs on the rear shocks, but I had the 3.1" on. Well I was trying to lower the ride height a little and could not get a consistent measurement. Each time I dropped the car on the table to measure, the reading would be 2 to 5mm difference each time. Anybody have suggestions on how to get a consistent read each time. If I could get a 1 to 2 mm difference each time I would be happy. I drop the car from the same height each time, about 6-8 inches.
#3329
Tech Adept
iTrader: (3)
Originally Posted by MannEdge
I know this was asked before, but could someone point me to the thread on Rctech about the throttle adjustment that someone wrote about and had pics? I tried looking for it, but I cannot seem to find it.
Thanks,
Manny
Thanks,
Manny
#3330
Tech Regular
iTrader: (19)
Originally Posted by jallshouse
here is the one i used, no problems so far http://www.teamlosi.com/ProdInfo/Fil...e_Addendum.pdf
Thanks,
Manny