Originally Posted by Fred Hubbard

You're welcome Nolan. Yeah not too bad after only having about 9 minutes of track time with it on asphalt for the 1st time. I was able to finish out front in my Q1 putting me 3rd going into the Q2. I made couple of changes and the car felt really good in warmup for Q2 but I stripped a rear belt and was relegated to 4th overall going into the main. My plan was to get a good start and get by 3rd fast enough to stay close to Rick and Barry which I did but hammered 3 different times by other cars thus ending my run. But I am extremly happy with the potential!! We were still able to secure a podium spot with Hiro finishing in 3rd (Nice work Hiro-San!). Attached is my setup.

Originally Posted by goots

what is the effect of using the outer hole on the rear hub? Ive been seeing allot of setup sheets lately using the outer hole.

Originally Posted by Korey Harbke

The car usually feels a lot smoother. I've found it tends to make the car rotate better in longer high speed corners as well, especially through the middle and exit of the corner.

Give it a shot

Originally Posted by Fred Hubbard

No Losi 90, that shock setup is or asphalt. On carpet I'm running 550cSt and 1.1mm 3 hole pistons.

Originally Posted by NolanP

Sounds like I'm sol on finishing my kit. That stupid washer is on back order. I can't find it us or otherwise right now.

Originally Posted by grippgoat

The instructions say it's 4.1x11.5x0.2mm.

This might be close enough to work with a little massaging:

http://www.spec-r.com/default/index....roducts_id=162

ID is going to be ~4mm, so you could enlarge that with a file if it's too small. I don't know about the OD, but it's probably in the right ballpark.

-Mike

Originally Posted by AGNO

With pistons 6x1,1 I use oil 500 Much More and work very well... at the last race with 13.5 Boost I scored the two best best lap of the race, the ambient temperature was 32 °c(90°f).

Tyres Sorex 36

Track medium grip

Originally Posted by NolanP

Thanks I sent em a message.

Anyone have one of these they are willing to part with? Odd spares.....Fred...Korey? I'll obviously pay for the part and shipping. I want to play with my TCXX this weekend.

Originally Posted by grippgoat

The instructions say it's 4.1x11.5x0.2mm.

This might be close enough to work with a little massaging:

http://www.spec-r.com/default/index....roducts_id=162

ID is going to be ~4mm, so you could enlarge that with a file if it's too small. I don't know about the OD, but it's probably in the right ballpark.

-Mike

Originally Posted by NolanP

emailed Spec-R and its the same part. Ordered em from Nexus. Thank you!!

Originally Posted by outtafocus

Anyone know where I can find a complete parts list for the TCXX?
I want to order a bunch of parts when I order my kit.

Are the suspension arms the same as TCX? I think that is what Fred had mentioned earlier.

Any other recommendations on parts besides the usual rear hubs, chubs and knuckles?

Never mind, found the parts list:
http://www.hpieurope.com/parts.php?lang=en&partNo=68299