IM RUNNING A LRP V7.1 W/ TRINITY D3 7T MOTOR W/ A 87 SPUR GEAR ON MY T4 WHAT PINION GEAR SHOULD RUN SO I DONT BURN UP MY MOTOR ETC THANKS GUYSSSSSS

v7.1? brushed? 7t is WAYYY too much motor lol. a brushless 7.5t is not equal to a 7t brushed.

ordered some pinons and another spur, so i have 75, 78, 81, 84 spurs, and 22t 24t 26t 28t 30t pinons, hopefully i can get a gear ratio that works

most likely going to start with 78/24 with a 10.5 in buggy and 84/22 on the 9.5 in the t4, unless anyone has other comments.

15t pinion

yeh i have a brushed 7t single motor with 87t spur and 15t pinion hawlsssssssssss assssssssssssss but i dont wanna burn it up so i wanted to no what would be a good gearing ratio for it

tip

*don't run it much longer than 5 min


* turn the com & replace brush's after 2 or 3 runs...

how long should i leave my motor cool down between runs?

How long ?
Till it has cooled off....(15<>20 min)

Just ordered front and rear V2 shocks for my B4.1 which is currently stock.
I run at an outdoor clay track with a good mix of bumps, straights and jumps.
What is a good weight of oil to start with for the fronts and rears in these shocks? Also, I ordered a variety pack of springs, what springs should I start with also?

Thanks all....Rick

http://teamassociated.com/setupsheets/RC10B4.1/

would the +8 chassis make a big difference on the handling of the buggy and also getting diff rebuilt with bfast balls and rings make a big difference what kind of balls should i get?

would the kyosho velvet shocks be better on b4.1 than the orignal shocks ?

+1 on the 8mm chassis, makes it handle like night and day.

The Bfast Kit is a waste. You can achieve the same results sanding your stock rings and using ceramic diff balls. Others on here will argue with this, but that is them.

The V2's are great shocks and work great.

hey guys currently looking for blue speaker wire to put on the lrp, would a 50 watt soldering iron work? I should i use a gun my bud has? \

http://www.amazon.com/COMPLETE-ENCLO...994928&sr=1-98

this ok?

50 watt should be ok. I have used a 40 watt iron in the past and did an ok job but not ideal.