It should be a hex driver. Try applying some heat.

i have useda small punch b4. or u can use a small hex driver.u may need to tap it out with a small hammer. u should have to really beat on it.

ok I'll try both heat and a small hammer. Will do when I get home tonight. I'll post when I figure it out.

btw: I really appreciate your help, this is how a hobby should be!

Use some plyers and feebly in the middle and move it back and forth as you twist it. This is why I like to let the pins rotate in the pin brace. If they become stuck in the middle of a main your handling will suck. If all else fails use a hammer and move it from end to end. I have had them get stuck until I started using an arm reamer.

was on amain bought the 13CB for 5 bucks SALE bought more then a few turns out they are pretty good

Protek CB

quick question, do you guys use the rubber gromets to mount steering servo?

i do i would use them espially as you know the beating the steering servos take when running truggy.

gromets it is!!! thanks

x2

ok, got new steering servo in, use gromets on throttle servo too?

Wow tc5 man has good info for once. A+ for you.

Make sure you don't over tighten they should be snug on all ends.

use rubber grommets on BOTH servos!

cool, thanks!

Same here