After a few crashes my front dog bones started to come out. Now they fall out even with a minor collision. Checked suspension and didn't see anything broken or bent. I race in stock class so can't install anything different. Anyone know what part I need to replace to stop it from happening?

Anyone have a good starting setup for running on black EOS carpet

Try putting a couple of O-rings on the inside of the cup to keep them more centered.

Tried that. It didn't work.
Something on the suspension is flexing more then it should.
I also tried switching rear cups and dogbone to the front, but it didn't help.

Having the same problem. Getting over it, and want to move on.

Have shimmed the slop out of the front hubs, but not sure what else to do.

SUPER GLUE!!!

Get any tire glue. It will hold better. Don't forget to clean and scuff the rims and tires.

How would you have a half tooth pinion?

yes, any pinion will "work". 17.5t is how many turns the motor is.

Seems like quite a few are running the tt02 r or rr.

I actually got the RR - seems like its the same as the R except for the blue chassis. It has all the main upgrades but I ordered a few more while staying within TCS rules, like the aluminum steering, motor heatsink, etc. To bad TCS doesn't allow the screw upgrade from the S... not so much for the weight savings but so that I don't have to use a Phillips screwdriver. I'll run this in our local USTG class to see if it is competitive. I'm very new to Tamiya in general. I know they have the 'pro' 419 chassis but that is to expensive for me since i'm in it mostly for fun and as a hobby. Hopefully this TT02 will be good enough to use in the USGT class.