85LikesTekin Rx8 Gen3 Thread
06-16-2018 | 12:00 PM
#182
I've sent this question to support a Tekin but thought I would ask the experts here while I wait for a reply.
What is the default 'Timing' setting on the Gen3 for a Tekin HDpro4 4300 (17/40 grear) and the HD 4600 (16/40) on my Tekno SCT410.3?
I was once told to use either Custom 1 or Custom 2 for a 4-pole motor.
Thanks
What is the default 'Timing' setting on the Gen3 for a Tekin HDpro4 4300 (17/40 grear) and the HD 4600 (16/40) on my Tekno SCT410.3?
I was once told to use either Custom 1 or Custom 2 for a 4-pole motor.
Thanks
06-16-2018 | 01:54 PM
#183
I've sent this question to support a Tekin but thought I would ask the experts here while I wait for a reply.
What is the default 'Timing' setting on the Gen3 for a Tekin HDpro4 4300 (17/40 grear) and the HD 4600 (16/40) on my Tekno SCT410.3?
I was once told to use either Custom 1 or Custom 2 for a 4-pole motor.
Thanks
What is the default 'Timing' setting on the Gen3 for a Tekin HDpro4 4300 (17/40 grear) and the HD 4600 (16/40) on my Tekno SCT410.3?
I was once told to use either Custom 1 or Custom 2 for a 4-pole motor.
Thanks
07-01-2018 | 09:56 AM
#188
Tech Apprentice
Joined: Dec 2008
Posts: 79
From: Denmark
No turbo in ver272
Hi
I just purchased a Tekin Rx8 gen3 and a bluetooth hotwire, I updated the hotwire and speedo, and with the software the new brake features appear, but I still dont have any turbo settings, neither on the computer or the App.
07-01-2018 | 08:48 PM
#189
07-02-2018 | 09:08 PM
#191
We don't need to boost or add turbo to most any car application the Rx8 is used in. What are you using it in that you feel needs this feature?
07-04-2018 | 01:27 PM
#193
Adding turbo/boost to a 1/8 motor will be a short term gain to a permanent destruction of your equipment. It's never a good idea. Batteries will not tolerate, and the motors are such a low wind that you will eventually break stuff. Timing advance alone when set too high can puff packs.
07-10-2018 | 03:15 AM
#194
Tech Regular
Joined: Jan 2002
Posts: 254
When will there be a speed controller and motor developped specifically for 1/8 on road cars ? Current speed controllers for 1/8 are very limited in setup options compared to 1/10 speed controllers for touring cars. Also the 1/8 motors are still a fully closed design whereas 1/10 motors are more and more having vent openings to exit heat. Seems like 1/8 speed controllers and motors have been standing still for many years and in 1/8 on road they are a limiting factor for performance today.
07-11-2018 | 06:22 PM
#195
Really need a 1900kv combo... Hopefully they come back in stock soon. Any body know if the combo will be including the new gen 3 motors sometime? http://www.teamtekin.com/t8.html
Last edited by savage24x; 07-12-2018 at 04:37 AM.
