Kyosho Inferno MP9 TKI4 1/8 Buggy Kit
|
|||
#422
Tech Regular
What is the distance between the two screws that holds the wing in place? I want to run the wing on my but don't want to cut holes. could someone please measure it. (preferably in mm), thanks.
#423
Only issue im having is for some reason my front brake disc keeps hitting the two screws that secure my brake pads (passenger side screw)....measurements are right, i replaced brake disc with a new one and it stopped but now its doing it again
#425
#426
Tech Regular
#427
There are no reliability issues on the TKI4. Cost of the kit is higher because you need no upgrade and you will be able to keep your kit for years in the future.. so it's justified.
I don't say the car perfect. But I don't know of any car which is nearer from perfect. If someone has heard of another car able to compete with the TKI4 all aspects considered, let us know.
I don't say the car perfect. But I don't know of any car which is nearer from perfect. If someone has heard of another car able to compete with the TKI4 all aspects considered, let us know.
#428
#429
Tech Regular
#430
Interesting stuff on Tebo's car at the World's Warm Up... I've never seen him use the aluminum rear chassis brace in competition before, or high front roll center or the front hole on the Akerman plate. Photos on Neobuggy.
#431
well it was a warm up/test event, probably trying things to get confident in his setup, like he said at neobuggy after winning, "if i think my car is working good, that's more important than my car actually working good"
#432
#433
I was wondering if some one could point me in the right place for this INFO
I understand this change for the TKI4 its adds more kick up right?
L = lower roll center
H = higher roll center
9= ?
Upside L is = ?
H lower = ?
6 =?
I understand the Rear side down and up holes
Then on the lower Plate IF486
front side
Holes - out bottom less kick up
Holes - out top more kick up
Holes - in bottom less kick up
Holes - in top more kick up
Rear side needs to match
top front side?
So if I'm in holes front side i need to be in hole rear side?
Thank you
I understand this change for the TKI4 its adds more kick up right?
L = lower roll center
H = higher roll center
9= ?
Upside L is = ?
H lower = ?
6 =?
I understand the Rear side down and up holes
Then on the lower Plate IF486
front side
Holes - out bottom less kick up
Holes - out top more kick up
Holes - in bottom less kick up
Holes - in top more kick up
Rear side needs to match
top front side?
So if I'm in holes front side i need to be in hole rear side?
Thank you
#434
Tech Master
The new part is the rear front plate (behind the gearbox) it gives the car LESS kickup.
You can not adjust kickup on on the IF486. The upper arms have nothing todo with kickup, only rollcnter, if you think geometry.
You can not adjust kickup on on the IF486. The upper arms have nothing todo with kickup, only rollcnter, if you think geometry.
#435