Hot Bodies D413 1/10 4WD Buggy
#9211
Tech Champion
iTrader: (32)
You will have fun! the track layout is fast and flowing. The double in the middle is REALLY easy to overshot. You can whip it pretty good as the lip pops yea.
FYI I changed his 2015 Ready race set up just a tad for this layout.
2 mm of limiters in the rear shocks and 1 degree of anti squat to keep the back end from coming around off power on the sweeper/roller after the straight.
I use Gold Dirt Webs front and rear with AKA foams.
FYI I changed his 2015 Ready race set up just a tad for this layout.
2 mm of limiters in the rear shocks and 1 degree of anti squat to keep the back end from coming around off power on the sweeper/roller after the straight.
I use Gold Dirt Webs front and rear with AKA foams.
Last edited by STLNLST; 05-22-2015 at 04:42 AM.
#9212
R/C Tech Elite Member
iTrader: (12)
Also, I can't seem to find diff gaskets without buying a spur gear. Am I just looking in the wrong place?
-Chris
#9213
No worries...With the shortage of dirt webs...its pretty common that the go to are Chainlinks.
Haven't tried them on the D413..but i have on my mod 2wd. The difference is super minimal at best. As long as they're broken in...they will be just fine.
Haven't tried them on the D413..but i have on my mod 2wd. The difference is super minimal at best. As long as they're broken in...they will be just fine.
#9214
I have some Kyosho P5's coming to see how those do on the next rebuild..currently I'm just reusing the gasket.
#9216
ohhhh 13.5 blinky? TBO...its freaking stacked down here and the track was designed for the "Stock Nats" so it's pretty open and fast. I would say add some timing for sure.
Dont know how long you're down here...but if you have time...try to also hit up IERC. It's another great indoor track down here. It's a little over an hour away(a bit out of your way) They also race on Sat, but open practice is on Sunday.
If you're heading back on Sunday...then there is a much smaller track on the way back up (off the 5) well really off the 14..just a few minutes though..but same direction @ SCVRC. Their racing starts at 2. The program is pretty short.
#9218
Broke a turnbuckle last night in a bad crash, thought I would have broke a lot more though. Ordered up some Lunsfords, anybody have any tips on using these?
#9220
What is the orientation of your solder tabs? If you were looking at the end of the motor where the solder tabs are while the motor is in the car are the tabs at 12 o'clock?
#9223
1:30 to 2:00 to the outside would be 10:30 to 11:00. How much extra wire do you have in your car?
#9224
But then I'd have to hear people crying on the driver stand when they blow their line in the main.
#9225
Hey all I'm looking to purchase a dedicated ESC for this car. Anyone have any reccomendations? I'm definitely going to run a mod motor in this monster... Suggestions for the right thing?