Nathan timothy Adolfo and angel shipped

This guy

Good seein ya old man

You looked very happy playing with Hektor

Ive just pulled my Picco .28 turbo engine apart after many moons of [ poorly done ] storage. Ive got new bearing on order. However; the sad part is - it looks like the wrist pin clip on the exhaust port side came out! Got a nice scar on P/S - not horrible - but certainly not good either. Is this something that can be fixed / or mitigated by your service? Will post a picture shortly.

If not I understand ... either way my brother and I have a handful of "vintage" picco big blocks for trucks - we will likely need work done on.

Look forward to your advisement.

Thanks In Advance,

Steve
Socal

Steve,a very light scratch can be blended in so as the sealing surfaces will lap in ok for a club racer/practice.......BUT deep scratched surfaces are not repairable.

Although you can send the set on with your next order and I will look at it in more detail. Ray

Hey Ray I sent you a email yesterday -subject picco 28

Well I'm in mill mode ... seeing whats worth sending your way.



So I got better lighting and a cleaner look at the damage on the P/S - sigghhhh - suspect she's a goner. New guts I think. Your thoughts?

Do you do piston lapping for new engines? Thanks

Hey Ray
just checking the status of my piston and sleeves. TIM G from California

Thanks

Hey Ray did you get my email.

Lighttravler- Ill see if I can connect your rctech handle with your actual name?

Tacomaster- I donot handle new engines, NO.

Tim G- your on the bench - I will be in the shop tonight and tomorrow night completing orders.

Ray

just got my p/s back from ray and the speed and quality is just amazing!!
thanks so much and will recommend you to all my buddies! mike. PS, Ray you have a PM.

Thanks mike. In regards to rebreakin question ,simply richen needle settings a half turn or so,and 4 tanks easy 1/2 throttle max. Should do it. Call me with any further questions.these pm's harder to manage sometimes.
Ray

Thanks Ray

thanks very much ray.

Again how. Much is the piston and sleeve job?