As I said in my previous post, I had to mod the spur gear, and whenever I use a plastic spur, I will use black sealant on one side of the paper gasket so it will seal right.

Can you give more info on the modification? Is it a specific size tool to create the countersink? I've never done some thing like that in all my hobbying days.

Very nice!
How much?

The front screw holes just need to be chamfered slightly. You can use a standard hand drill with a generic hardware store countersink. You don't need to remove that much material, just enough that the screw can tighten the plate down completely.

Is there a combo price if you buy front and back and tools.

I did not get any white pistons I got the Piston on the tree.

Do they come in the eb48.2 kit?

also, 2 of my shocks the piston are not smooth.

and I bought the opt. 8.1.3 tekno piston and two of them are not smooth
did i get some bad pistons?

I may have to sand two of the pistons down the opt ones that is...

Haha I'm so confused... I think I thought you were asking if the optional 8x1.3 pistons come on a parts tree, which no they don't. .2 comes with black pistons on a tree I think they're 10x1.2.

When u cut off parts tree yes u may need to sand nub but idk why whites 8x1.3 would not be smooth?

I know..
the white piston two of them.

I will run them and see if they loosing up

What servo horn are you guys using with the hi tech 7955t servo?

I am using the hot bodies servo horn it works great

So I just got my eb48.2 together. Measured everything as directed. My front camber even on the outside hole on the steering knuckle is +5*. ! Looks like I'm going to be roasting the outer edges of my tires..... Am I missing something here? Any help is appreciated!

http://www.teknorc.com/shop/tkr5252-...rn-24t-spline/

I use the racers edge ones. You do need to put some sort of riser to get everything level though.

Do you have a .1? Hard to tell you without pics, if u post a couple w wheels off I'm sure we could help. And I'm finishing my .2 build tonight so ill let u know if I have same results but this is my 3rd tekno kit in 6 months so i already know where everything goes mostly.

I use the OFNA seen on the first page which needs 2-3 washers at the link so its level but works great.