5LikesSC10 4x4 Thread
08-10-2012 | 05:44 PM
Tech Elite
Joined: Nov 2011
Posts: 3,936
From: roseburg or
Depends on how you go about it.
I use a ball end 2mm hex and everything stays in place.
Some dremmel a section out of the belt guide so you can go straight into the pinion screw without needing a ball end hex driver.
Some drill a hole in the bottom of the chassis so you can get a hex driver up to the pinion screw.
Some take the motor out regardless of pinion size if they haven't figured out the above methods.
I use a ball end 2mm hex and everything stays in place.
Some dremmel a section out of the belt guide so you can go straight into the pinion screw without needing a ball end hex driver.
Some drill a hole in the bottom of the chassis so you can get a hex driver up to the pinion screw.
Some take the motor out regardless of pinion size if they haven't figured out the above methods.
08-10-2012 | 05:45 PM
08-10-2012 | 05:48 PM
That would probably be faster than my truck with the tenshock in it.
08-10-2012 | 06:27 PM
Tech Regular
iTrader: (4)
Joined: Jul 2012
Posts: 451
From: tx rchq
or go 1/8 motors
08-10-2012 | 06:51 PM
Tech Master
iTrader: (13)
Joined: Nov 2009
Posts: 1,207
08-10-2012 | 07:14 PM
Tech Regular
iTrader: (4)
Joined: Jul 2012
Posts: 451
From: tx rchq
hight and day but both setups worked pushes more with mip to meny thing to list but way more stable i run on a big track that is smooth try the inside holes on the arms and stand the shocks up more travel but if traction comes up you will roll this is ok if you dont over drive the truck
08-10-2012 | 07:39 PM
so gear changes take 1 more screw then normal, but really how often do you change gear
