Thanks guys. I used the dremell (sp) to grind down one of the serpent metal servo horns. I think it will work well.

Also a +1 with the Hot Bodies servo horn. Love it!

What size are the holes in the Serpent 8-hole conical pistons? Part 600350

1.1mm

Thanks, that makes it much more easy to understand the type of track one is racing on!

There have been a few people asking for my setup I haven't forgotten just been dam busy to lay down on a setup sheet will do it by Fri and I'll send over so you have for the weekend sorry guys

They are 1.2mm

Went with the Hot Bodies Aluminum horn as mentioned further back in the posts. Fits perfectly, no clearance issues.

No problem Jay, folks get busy, i know! Thanks for your help thus far.

its close but io dremel used the sanding bit just to smooth it down a bit,and it misses

I think the plastic arm (where your finger is) is installed upside down.... Unless you just had it installed up side down in your picture (and not running on the car that way)....Quite a few guys run them upside down like you show it, (by mistake), cause when you press the front ball stud thru...for the plastic arm to end up in the correct orientation, it "has" to be pressed thru from the "smaller" holed side of the arm, and not the slightly larger tapered side...the way it should have been manufactured on that piece (IE: larger hole on the opposite side).....

not sure how big of a difference this makes running(prob not much), but when it's flipped over from the way the book shows it...it looks to exhibit more of an arcing motion to the linkage, rather than a more precise straighter motion.... Joe

Also, another option (when running aluminum servo horns) is to get rid of all the plastic shims underneath the servo anchor screws altogether (further reducing servo flex), and run your plastic arm to the "outside" of your aluminum servo horn (instead of inside)..... this setup (with most servos) will allow the arm to be aligned nice and straight... And not contact anything at all........ Joe

Has I have just swapped out servo's for Orion Vds, had a Futaba in, just going Hv,and waiting on my HB servo horn will be removing the spacers,has the vds doesn't sit right with the spacers,and the Fullforce clamps don't clamp had good either,mmm

So will be on the other side

My Serpent 811BE painted by Neesh!
Made in Hawaii.



Awesome as usual!

Quick Question, does anyone know if the Ezrun 150amp ESC fit Ok in the serpent.

Thanks

Ross