What exactly is the 8mm mod?

Is that just using the carbon b4.1 hub extensions on the rear hubs?

yes and most are using 6mm-7mm on the inner ballstud with this mod too, so you need a pair of 12mm ballstuds also

Thanks Jake...that's really going to alter the roll center...my truck is pretty good how it is now.

Might be worth a try!

yeah i have ran my truck both ways, and the 8mm mod made the truck drive completely different, which it was a GOOD different...

i let a few people drive my truck after i did this mod and i overheard people talking about it and i heard "it didnt even drive like a corr truck"

I have some info and video up from the Shortcourse Showdown that was at TRCR in Tacoma, WA this past weekend on thebigsc.com. I will have some more stuff up tomorrow.

So are the rumors true ?

Been awhile since I was on this thread, what rumors?

Short Course Showdown Nationwide Tour - Tacoma RC Raceway - 4wd SC A-main
Brian Kinwald throwing it down in 4x4, Michael Schoetler ran great until an electronics failure struck.

+ YouTube Video

Does anyone know if BK ever posts his setups anywhere? Someone once told me he does not post them , because they are crazy complicated. And can often be seen using self customized parts.

He did make a lot of parts back when he raced for Xfactory. Im sure he makes parts still

He does have a ton of custom stuff on his kits, I saw some diagrams floating around for his sc10 2wd sway bars, but didn't inquire on the 4x4. If he posted a setup it would have to include a 4 page supplementary guide.

I need to move my receiver away from my esc. there seems to be an interference issue. I know some people said drill a hole and CA an antennae in... yeah, kinda ghetto for me. I am looking for a mount that I can use and make a clean install with. I will probably mount it on the left front of the chassis. There is a screw hole there that looks like it is counter sunk and ready to go. I have seen a few people mount it there, but was never sure who made the mount. I could also use this one, I would just need to mark and drill 3 holes.

http://www.amainhobbies.com/product_...-Antenna-Mount

Looking for a few ideas here.

I was looking at the pics of his truck on the bigrc site. Whats that gold bling to the left and right of his servo? Weight?

Yeah, brass weights.

Brass chassis weighs, off a tc6 I think.

When I ran a 550 motor, I ran 1 1/2 oz of tungsten in the same spot.