R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: hacker07
Showing results 1 to 25 of 500
Search took 0.13 seconds.
Forum: Electric Off-Road
08-14-2023, 08:46 AM
Replies: 283
Views: 56,417
Posted By hacker07

You know something...I try to support everyone as...

You know something...I try to support everyone as much as possible. I take the time to share my experiences with folks, such as I have not seen that issue at all. But at least I am always...
Forum: Electric Off-Road
08-14-2023, 08:30 AM
Replies: 283
Views: 56,417
Posted By hacker07

No one should have to grind their servo. None of...

No one should have to grind their servo. None of the people that have RUN it have ground their servo. None of them have a witness mark on their servo or their driveshaft.
Forum: Electric Off-Road
08-14-2023, 08:29 AM
Replies: 283
Views: 56,417
Posted By hacker07

This chassis has now been run on over 30...

This chassis has now been run on over 30 different vehicles, both nitro and electric. Not one of them has a witness mark on the driveshaft. Run the chassis.
Forum: Nitro Off-Road
08-14-2023, 08:22 AM
Replies: 1,934
Views: 448,701
Posted By hacker07

Nothing was ever "confirmed" on either of their...

Nothing was ever "confirmed" on either of their cars. I stated that both of them are running it with no issues or even witness mark on the driveshaft.
Forum: Nitro Off-Road
09-23-2019, 02:41 PM
Replies: 1,934
Views: 448,701
Posted By hacker07

The carb ball is something you typically loosen...

The carb ball is something you typically loosen and rotate to get it at the correct plain, have you adjusted this?
Forum: Electric Off-Road
09-23-2019, 02:38 PM
Replies: 833
Views: 292,469
Posted By hacker07

We did a ton of testing on the car before release...

We did a ton of testing on the car before release and didnt have any issue here. Once released, we have had some customers say they would like stronger shock shafts. So, we went back and did a lot...
Forum: Nitro Off-Road
06-12-2019, 11:33 AM
Replies: 719
Views: 188,914
Posted By hacker07

Dakotah is running a 8T 4.0 with the 8X rear hub...

Dakotah is running a 8T 4.0 with the 8X rear hub on it. You have to then also use the 8X rod ends with th e4.0 turnbuckle to make it long enough. You put the axle in the hub, then 1.5mm of axles...
Forum: Nitro Off-Road
06-11-2019, 10:16 AM
Replies: 1,934
Views: 448,701
Posted By hacker07

Dakotah has been working through issues here and...

Dakotah has been working through issues here and there. Worlds was a flame out in a bump spot. He was having trouble with the fuel he was having to use there as it was different. Silver state, he...
Forum: Nitro Off-Road
01-10-2019, 08:05 AM
Replies: 1,934
Views: 448,701
Posted By hacker07

Yeah, I think a few different starter boxes out...

Yeah, I think a few different starter boxes out there may work just fine. The TLR one happens to be made to support just our cars. There are many others that can be much more universal really. If...
Forum: Nitro Off-Road
01-09-2019, 07:19 AM
Replies: 1,934
Views: 448,701
Posted By hacker07

OK, so do NOT loosen these screws. Sorry, just...

OK, so do NOT loosen these screws. Sorry, just dont want you to break something due to this.

I would dremel the spindle until the anodization is off the top and bottom and put back in place and...
Forum: Nitro Off-Road
01-08-2019, 11:50 AM
Replies: 1,934
Views: 448,701
Posted By hacker07

Pretty much what he says here. The one caveat is...

Pretty much what he says here. The one caveat is to make sure you build it like a bladder meaning with the screw in place. Build. Bleed. Then remove the screw when done.
Forum: Nitro Off-Road
01-07-2019, 02:45 PM
Replies: 1,934
Views: 448,701
Posted By hacker07

We finished at 10/10/4 at worlds as the grip came...

We finished at 10/10/4 at worlds as the grip came up and this calmed the car down a bit.
Forum: Nitro Off-Road
01-07-2019, 02:32 PM
Replies: 1,934
Views: 448,701
Posted By hacker07

That is from the grease that is in the bearings.

That is from the grease that is in the bearings.
Forum: Nitro Off-Road
01-07-2019, 02:31 PM
Replies: 1,934
Views: 448,701
Posted By hacker07

The kick up at any of the pills level is the same...

The kick up at any of the pills level is the same 12 degrees.
Forum: Nitro Off-Road
06-01-2018, 12:28 PM
Replies: 1,534
Views: 429,839
Posted By hacker07

Sorry, no 8ight T-E 4.0 on the way. We have...

Sorry, no 8ight T-E 4.0 on the way. We have posted this many places, I guess this place got missed. There is just not a call and we cannot sell a vehicle that has such low sales volume.
Forum: Nitro Off-Road
06-01-2018, 12:08 PM
Replies: 1,534
Views: 429,839
Posted By hacker07

I have seen this most often with Reds engines. ...

I have seen this most often with Reds engines. The way the throat and their throttle body come up puts the boot at an angle that hits the body. If you place the body on the vehicle, it should not...
Forum: Nitro Off-Road
04-03-2018, 03:22 PM
Replies: 1,534
Views: 429,839
Posted By hacker07

Its great to see debates like this as there are...

Its great to see debates like this as there are always two sides to any thing you can run or test. Pillow balls huh? Interesting.

As far as if they can work in the states...I think the top...
Forum: Radio and Electronics
03-19-2018, 07:52 AM
Replies: 2,162
Views: 545,359
Posted By hacker07

The DX6R does not have an inactivity alarm. ...

The DX6R does not have an inactivity alarm. Since it is designed to be set back on the docking station/charger, there is no inactivity alarm.
Forum: Radio and Electronics
02-13-2018, 11:30 AM
Replies: 2,162
Views: 545,359
Posted By hacker07

They are correct, this question wont be answered...

They are correct, this question wont be answered and mentioning its the third time its been asked makes it worse, not better. When Nick can talk about it, he will.
Forum: Radio and Electronics
02-12-2018, 08:37 AM
Replies: 2,162
Views: 545,359
Posted By hacker07

And also something to keep in mind, while it is...

And also something to keep in mind, while it is Android and you can do other things due to this, the primary reason was always that it is touchscreen. This allows for a more user friendly experience...
Forum: Nitro Off-Road
02-12-2018, 08:34 AM
Replies: 1,534
Views: 429,839
Posted By hacker07

We often have our A level team drivers testing...

We often have our A level team drivers testing ideas. Reno has been testing a particular idea and gone back to back a number of times. That is why he is running those particular shocks.
Forum: Radio and Electronics
02-09-2018, 02:21 PM
Replies: 2,162
Views: 545,359
Posted By hacker07

Yes, it does come with all of the same items.

Yes, it does come with all of the same items.
Forum: Nitro Off-Road
02-05-2018, 02:56 PM
Replies: 1,534
Views: 429,839
Posted By hacker07

I am sorry that this is the case. The spring...

I am sorry that this is the case. The spring cups you need are the ones that come with the shock ends and so most have so many of these hanging around, we didnt feel it was necessary. Sorry for the...
Forum: Nitro Off-Road
02-01-2018, 08:55 AM
Replies: 1,534
Views: 429,839
Posted By hacker07

The EVO springs are much better everywhere. I...

The EVO springs are much better everywhere. I would suggest trying them out. If you want the closest rates, it would be yellow fronts and red rears. However the springs just work different due to...
Forum: Radio and Electronics
01-23-2018, 08:18 AM
Replies: 2,162
Views: 545,359
Posted By hacker07

Youtube and Android

Here is the fix off of the Android forums as well as this is an Android issue:

Had the same problem, here's how to fix it.
It takes a little time but does work.
When the Unfortunately... notice...
Showing results 1 to 25 of 500
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.