R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
 
Page 1 of 13
1
2
3
11
Last »
Search: Posts Made By: rokosam
Showing results 1 to 25 of 310
Search took 0.02 seconds.
Forum: Team and Company Discussions
06-17-2019, 02:01 AM
Replies: 25
Views: 5,938
Posted By rokosam

Thaks for the photo, i installed the same way but...

Thaks for the photo, i installed the same way but at the bottom of the rear pod, and yes rear tires get very close of carbon fiber but no problem using some rear axle shims.
Forum: Team and Company Discussions
05-27-2019, 01:28 AM
Replies: 25
Views: 5,938
Posted By rokosam

Indepedent rear wing mount for Xray X1 (CXF-001)

Hi, I ordered one of this for my oldie first Xray X1 version. Can you tell how and where to install the rear motor stiffer, I assume in between some of the rear bulkhead holes from side to side.
...
Forum: Electric On-Road
07-17-2015, 11:20 AM
Replies: 7
Views: 2,272
Posted By rokosam

Wheel balancer for F1 rubber tires (F104)

Hello, how do you balance your F1 rubber tires?, Front tires seem to need a good balance very usually.

Regards
Forum: Electric On-Road
02-22-2015, 06:18 AM
Replies: 3,205
Views: 994,933
Posted By rokosam

Looking at Janīs last ETS setup (Muelheim...

Looking at Janīs last ETS setup (Muelheim Kaerlich) it says 4,5 mm (9 x0,5 mm shims) over steering blocks. I have changed roll center using 4 mm shims under lower front arms but I donīt have space...
Forum: Electric On-Road
02-22-2015, 01:36 AM
Replies: 3,205
Views: 994,933
Posted By rokosam

Ok. We will try that setup wiht Rides for carpet.

Ok. We will try that setup wiht Rides for carpet.
Forum: Electric On-Road
02-21-2015, 03:37 PM
Replies: 3,205
Views: 994,933
Posted By rokosam

Which front springs you use on carpet with R1...

Which front springs you use on carpet with R1 Ride rubbers? I tried today Ride R1 with original box setup and the car tends to slip from the back, much better with Solaris tires S-TFF0MS1H/...
Forum: Electric On-Road
09-20-2014, 02:34 AM
Replies: 70
Views: 15,139
Posted By rokosam

About 6-8 minutes in 220 Lola config. You can...

About 6-8 minutes in 220 Lola config. You can find more info from the french drivers at this link:


http://www.rcmag.com/modules.php?name=Forums&file=viewtopic&p=794465
Forum: Electric On-Road
09-15-2014, 02:43 AM
Replies: 70
Views: 15,139
Posted By rokosam

ESC: 1/8 Toro 150A Motor: Turnigy Trackstar...

ESC: 1/8 Toro 150A
Motor: Turnigy Trackstar 5600 kv 4 poles 5 mm axle
Lipo: LRP 4500 mah 11.1V
Gear ratio: 86/23
Forum: Electric On-Road
09-14-2014, 11:35 AM
Replies: 70
Views: 15,139
Posted By rokosam

EDAM Espirits running with 3S lipos: ...

EDAM Espirits running with 3S lipos:

PRgvGG3fC6Q
Forum: Electric On-Road
01-12-2014, 12:41 AM
Replies: 7
Views: 2,784
Posted By rokosam

Yes, I was talking about different kind of...

Yes, I was talking about different kind of motors.

(Team Powers Plutonium 4.5T offers 7700 kv (rpm/volt), sensor at 0 position as is described at its manual guide.)


Thanks.
Forum: Electric On-Road
01-11-2014, 04:05 PM
Replies: 7
Views: 2,784
Posted By rokosam

To go up ratio means shorter gearing?, you mean a...

To go up ratio means shorter gearing?, you mean a final number ratio larger with 11.1 volts than 7.4?

But 4.5T is 7700 kv and 4 poles short course motor is 4800 kv..

7700x 7,4=56980

4800 x...
Forum: Electric On-Road
01-11-2014, 03:50 AM
Replies: 7
Views: 2,784
Posted By rokosam

Lipo voltage, motor kv and gear ratios.

Hello, my doubt is if with 3S lipos (11.1V) i have to use a shorter ratio (large number) than with 2S lipos (7.4 v) with same number of kv but i suppose it also deppends on number of motor kv...
...
Forum: Electric On-Road
12-15-2013, 03:45 PM
Replies: 9
Views: 4,099
Posted By rokosam

Which lipos are used with this car 3S or 4S...

Which lipos are used with this car 3S or 4S lipos?

Thereīs space for a 1/8 ESC and 1/8 brushless motor as well?

Regards
Forum: Electric On-Road
12-12-2013, 01:53 PM
Replies: 177
Views: 68,198
Posted By rokosam

GREAT!!!!!

GREAT!!!!!
Forum: Electric On-Road
11-30-2013, 11:41 AM
Replies: 70
Views: 15,139
Posted By rokosam

Searching on youtube i found this video, they are...

Searching on youtube i found this video, they are not ESpirits 220 GPRs but Kyoshos 1/10 nitro converted to electric using 4S lipos electronics, Lola bodies and GPR superbarchetta foams . Same...
Forum: Electric On-Road
10-17-2013, 09:00 AM
Replies: 20
Views: 5,066
Posted By rokosam

Yes they fit, F104 type I think, indeed, I have...

Yes they fit, F104 type I think, indeed, I have installed a QTEQ fiber T plate .
Forum: Electric On-Road
10-16-2013, 04:09 PM
Replies: 70
Views: 15,139
Posted By rokosam

NDZ, I am going to use Espirit with this combo: ...

NDZ, I am going to use Espirit with this combo:

HobbyWing Combo SCT-PRO-A Xerun-SCT Pro esc + 3672 Motor
[HW-COMBO-SCT-PRO-A]

ESC is 120A-760A 2S-4S lipos

Motor is 4000 kv 550 size and 5 mm...
Forum: Electric On-Road
10-16-2013, 12:44 AM
Replies: 20
Views: 5,066
Posted By rokosam

Sorry I usually only run foams on asphalt, you...

Sorry I usually only run foams on asphalt, you have to use 0.020 spring no 8429 from Team Associated in the front side damper. For the central big damper I use Tamiya red spring (soft) and 300-350...
Forum: Electric On-Road
10-16-2013, 12:21 AM
Replies: 70
Views: 15,139
Posted By rokosam

I broke sintered rotor of my 4.5T with this car,...

I broke sintered rotor of my 4.5T with this car, this can also happen with "ordinary" 190 mm touring electric cars but I think this car needs 3S 11.1V and a 4 pole short course motor 540/550 to work...
Forum: Electric On-Road
10-15-2013, 01:10 PM
Replies: 20
Views: 5,066
Posted By rokosam

Yes I am, and I think is as good as F104 ver2.

Yes I am, and I think is as good as F104 ver2.
Forum: Electric On-Road
10-13-2013, 06:17 AM
Replies: 70
Views: 15,139
Posted By rokosam

Lehner 1930 series are 550 size i think but they...

Lehner 1930 series are 550 size i think but they are really very expensive.:cry:
Forum: Electric On-Road
10-13-2013, 05:50 AM
Replies: 70
Views: 15,139
Posted By rokosam

NDZ, Lehner motor is some kind of 550 size...

NDZ, Lehner motor is some kind of 550 size bruhless motor?, I think 11.1V + 550 sized motors are the key with this car. I broke 4.5T 540 rotor last week in 2S config. You said you fired your RX8...
Forum: Electric On-Road
09-23-2013, 02:05 PM
Replies: 177
Views: 68,198
Posted By rokosam

Here you have a EDAM 220 mm, using 2S, imagine...

Here you have a EDAM 220 mm, using 2S, imagine with 3S lipos:

zaHaFSkdCN0
Forum: Electric On-Road
09-23-2013, 02:00 PM
Replies: 177
Views: 68,198
Posted By rokosam

Electric Lola 220 mm exists, EDAM has one kit....

Electric Lola 220 mm exists, EDAM has one kit. And yes these chassis are made for 3S 11.1V lipos in mind. 2S 7,4V are for 190 mm.
Forum: Electric On-Road
09-20-2013, 02:29 PM
Replies: 177
Views: 68,198
Posted By rokosam

These kind of cars are perfect if you have a big...

These kind of cars are perfect if you have a big nitro track and want a durable and hard car. There are no races for them at the moment, but for training and for fun itīs just the best option.
Showing results 1 to 25 of 310
 
Page 1 of 13
1
2
3
11
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.