R/C Tech Forums - Search Results

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Community
Wiki Posts
Search
 
Search: Posts Made By: snowninja
Showing results 1 to 25 of 217
Search took 0.02 seconds.
11-22-2023, 09:28 AM
Replies: 142
Views: 25,469
Posted By snowninja

ordered and on the way, its been a few years...

ordered and on the way, its been a few years since i moved to another brand sct4x4 and looking forward to seeing what tekno has put together in this version!!
07-13-2021, 04:49 PM
Replies: 1,629
Views: 483,974
Posted By snowninja

DE makes some good wheels as well. At this...

DE makes some good wheels as well.

At this Point for 1/8 buggy is more about the materials,some are downright junk and will Crack in certain temps
07-07-2021, 01:12 PM
Replies: 1,629
Views: 483,974
Posted By snowninja

i wrapped the allen key with electrical tape...

i wrapped the allen key with electrical tape about 1/4" from the end, keeps it from going in too far and helps apply pressure to get the nut started. also helps to turn counter clockwise until you...
07-07-2021, 01:09 PM
Replies: 1,629
Views: 483,974
Posted By snowninja

brass is heavier than stock nut, i use them (on...

brass is heavier than stock nut, i use them (on the bottom ball) but have not tried back to back to see if they really make a difference in fwd traction
06-21-2021, 04:10 PM
Replies: 1,629
Views: 483,974
Posted By snowninja

goes without saying, just keep it clean - blow...

goes without saying, just keep it clean - blow balls out with air compressor , dont oil or grease.

when tightening the nut i leave enough play so the hub has a couple mm of play, keeps suspension...
06-12-2021, 09:17 AM
Replies: 961
Views: 189,723
Posted By snowninja

Thanks! The whole track slopes down in that...

Thanks! The whole track slopes down in that direction of the corner. That section is very offcambe and drops a couple feet into the corner entrance, that was the last section I built and was kinda...
06-11-2021, 08:39 PM
Replies: 961
Views: 189,723
Posted By snowninja

thanks!

thanks!
06-10-2021, 10:28 PM
Replies: 11
Views: 1,852
Posted By snowninja

It just didn't work for me. Maybe I was too...

It just didn't work for me. Maybe I was too green..
06-09-2021, 02:45 PM
Replies: 7
Views: 3,701
Posted By snowninja

yes, i have the sting and lesner, only about 10...

yes, i have the sting and lesner, only about 10 minutes on the sting. its a good pattern so far i like them. minimal wear on an abrasive surface but i would expect that from any m3 tire
06-09-2021, 02:19 PM
Replies: 11
Views: 1,852
Posted By snowninja

sold my eb410 to get the xb4.. regretted it the...

sold my eb410 to get the xb4.. regretted it the first time i put it on the track
06-09-2021, 01:50 PM
Replies: 961
Views: 189,723
Posted By snowninja

https://cimg2.ibsrv.net/gimg/www.rctech.net-vbulle...

https://cimg2.ibsrv.net/gimg/www.rctech.net-vbulletin/2000x1124/20210519_205506_ab07f98038673a344f69a7b63fb639ab2fd841c4.jpg
06-09-2021, 12:26 PM
Replies: 4,347
Views: 1,152,248
Posted By snowninja

nothing special needed to build but a snap ring...

nothing special needed to build but a snap ring plier comes in handy when needing to service the F/R center cvd's.

in general get some MIP speed tips and use a power driver (go slow so you don't...
06-08-2021, 10:29 AM
Replies: 1,629
Views: 483,974
Posted By snowninja

same.. i was missing a shock bladder and they...

same.. i was missing a shock bladder and they sent one out the next day, i needed to send of a pic of receipt and certificate of authentication.. funnily i found the missing bladder a few days later...
06-06-2021, 10:10 PM
Replies: 1,629
Views: 483,974
Posted By snowninja

they start out smooth but after 15k++ laps by...

they start out smooth but after 15k++ laps by sunday they get blown out, rutted and bumpy from bowls to sharp edges with vertical drops.. also i found the 8x1.2 pistons work best on the ebuggy but...
06-06-2021, 08:53 AM
Replies: 4,347
Views: 1,152,248
Posted By snowninja

my second weekend of racing the '21 and so far so...

my second weekend of racing the '21 and so far so good. i am playing with oils but so far 6x1.3 and 550/450 seems to be working well. the track conditions were polar opposites, one was pretty smooth...
06-06-2021, 08:29 AM
Replies: 1,629
Views: 483,974
Posted By snowninja

kit - 4 dot front., 3 dot rear i put 3 dot...

kit - 4 dot front., 3 dot rear

i put 3 dot on the front of my .20 and 21, i have not played with springs other than this but for our tracks this combo works well.
06-06-2021, 08:01 AM
Replies: 67
Views: 17,948
Posted By snowninja

my xray xb8 '21 and its been a pleasure in all...

my xray xb8 '21 and its been a pleasure in all aspects. amazing build quality, super durable, and no need for performance upgrades.. its great right out of the box.
03-30-2021, 12:24 PM
Replies: 5
Views: 1,729
Posted By snowninja

TTT

TTT
02-01-2021, 01:47 PM
Replies: 1,629
Views: 483,974
Posted By snowninja

Northwest - WA, ID, OR

Northwest - WA, ID, OR
01-28-2021, 01:18 PM
Replies: 1,629
Views: 483,974
Posted By snowninja

I have a great set up on my '18, do you think it...

I have a great set up on my '18, do you think it will mostly carry over to the '20?
01-28-2021, 09:06 AM
Replies: 1,629
Views: 483,974
Posted By snowninja

getting ready to build a new kit, are there any...

getting ready to build a new kit, are there any must have upgrades for the '20?
01-19-2021, 09:35 AM
Replies: 5
Views: 1,729
Posted By snowninja

TTT

TTT
01-01-2021, 08:53 AM
Replies: 5
Views: 1,729
Posted By snowninja

TTT

TTT
12-20-2020, 03:40 PM
Replies: 5
Views: 1,729
Posted By snowninja

TTT

TTT
12-17-2020, 08:38 PM
Replies: 5
Views: 1,729
Posted By snowninja

mugen mbx7t for sale

mbx8t front arms
mbx8t radio box
includes srt bh9037 servers (less than 2hrs of drive time)
also includes mugen clutch and fuel tank (not pictured)
some spares including 7 radio box..
also...
Showing results 1 to 25 of 217
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.