R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
 
Page 1 of 2
1
2
Search: Posts Made By: blue247carz
Showing results 1 to 25 of 47
Search took 0.01 seconds.
Forum: Electric On-Road
03-11-2015, 03:16 AM
Replies: 1,214
Views: 340,829
Posted By blue247carz

The upper ball is still supported by the spring. ...

The upper ball is still supported by the spring.

The lower is held in between the carbon arm which is shaped to the ball and the aluminium king pin end which is also shaped.
Forum: Electric On-Road
03-09-2015, 10:43 AM
Replies: 1,214
Views: 340,829
Posted By blue247carz

Kit comes with all bulkheads etc but says on box...

Kit comes with all bulkheads etc but says on box and instructions it will only fit TRF cars...101 & 101W
Forum: Electric On-Road
03-09-2015, 10:08 AM
Replies: 1,214
Views: 340,829
Posted By blue247carz

Just got my carbon front suspension set through...

Just got my carbon front suspension set through and bolted it staright onto my TRF101W to narrow the front end, it says on the box that its for both the 101 & 101W cars and utilises all the revisions...
Forum: Electric On-Road
02-16-2015, 01:50 PM
Replies: 1,214
Views: 340,829
Posted By blue247carz

Actually on further inspection all the aluminium...

Actually on further inspection all the aluminium bulkheads and parts etc are the same as the 101W so all I would need is the carbon parts and the small plates that fit on the end of the wishbones...
Forum: Electric On-Road
02-16-2015, 01:32 PM
Replies: 1,214
Views: 340,829
Posted By blue247carz

Thanks for the reply, yes I thought it looked...

Thanks for the reply, yes I thought it looked narrower than the one on mine but not sure if it would bolt straight on...
Im running indoor on carpet but may run it outdoor on asphalt in the summer.
Forum: Electric On-Road
02-15-2015, 11:58 AM
Replies: 1,214
Views: 340,829
Posted By blue247carz

Just bought my 1st F1 kit and opted for the...

Just bought my 1st F1 kit and opted for the TRF101W, I didn't realise that this kit was designed to perform with foam tyres, the car builds up lovely but the front end is massively wide. I have run...
Forum: Radio and Electronics
05-05-2011, 01:48 PM
Replies: 12,554
Views: 1,881,357
Posted By blue247carz

Thanks for the response Defcone, I have also...

Thanks for the response Defcone, I have also contacted HW Tech and they said I should be running 119 mod firmware, will give this a go before I blow anything up!!!

Cheers Paul
Forum: Radio and Electronics
05-03-2011, 03:20 PM
Replies: 12,554
Views: 1,881,357
Posted By blue247carz

Hobbywing 120a V2.1 esc supercharger firmaware for mod motors

Hi Guys wonder if anyone can help, just converted to the HW V2.1 120A esc from my SP GT2.0 Pro. The HW esc seems to have a little less punch but seems to run higher timing than my SP version even...
Forum: Electric On-Road
12-13-2010, 03:15 PM
Replies: 10,622
Views: 1,517,863
Posted By blue247carz

If you have high traction I find the trf lipo...

If you have high traction I find the trf lipo chassis works better with the original top deck that came with the car, It's slightly wider and stiffer. Make sure you sand the top decks down front and...
Forum: Electric On-Road
09-29-2010, 11:46 AM
Replies: 2,947
Views: 426,588
Posted By blue247carz

GM 120a v2010 £199.99 ...

GM 120a v2010 £199.99

www.demonpowerproducts.co.uk

Got everything GM esc's, motors, programming cables, plus all other bits you need.

Cheers
Forum: UK Racing
09-24-2010, 03:47 PM
Replies: 18
Views: 15,149
Posted By blue247carz

Hi Guys, been over to Moto Arena today and lots...

Hi Guys, been over to Moto Arena today and lots has changed already, the track is still layed with the guttering atm but most of the anchors have been removed so there is lots of flex now. Also they...
Forum: Electric On-Road
07-15-2010, 03:19 AM
Replies: 1,996
Views: 528,014
Posted By blue247carz

Hey Jilles well done at the worlds! It all...

Hey Jilles well done at the worlds! It all started with the interference, if it were not for that you would have been pole and had a clear track to show your true speed that all could see from...
Forum: Electric On-Road
07-01-2010, 01:32 PM
Replies: 10,622
Views: 1,517,863
Posted By blue247carz

[QUOTE=jonest;7615709]could they be running "Non...

[QUOTE=jonest;7615709]could they be running "Non Tamiya" chassis? :weird::sweat: just kidding..[/QUOTE

I was actually thinking the same thing, bet he is testing another make of chassis like the...
Forum: Electric On-Road
06-25-2010, 03:40 AM
Replies: 1,996
Views: 528,014
Posted By blue247carz

Thanks Craig my Bad double checked the manual and...

Thanks Craig my Bad double checked the manual and it does show both gold springs being used, I just found it difficult to get the 2nd one on so guessed it was a spare.... Rookie mistake.

I have...
Forum: Electric On-Road
06-23-2010, 03:01 PM
Replies: 1,996
Views: 528,014
Posted By blue247carz

Hey Jilles all the support from a true top 5...

Hey Jilles all the support from a true top 5 racer is great, it would be nice to see some of the other top guys getting involved.

1, My query is about the servo saver, I currently run the TRF blue...
Forum: Electric On-Road
06-23-2010, 02:38 PM
Replies: 358
Views: 75,682
Posted By blue247carz

You should have seen Elliot Harper at the last...

You should have seen Elliot Harper at the last BRCA Nationals Cotswolds, Hara, Grainger, Moore, Jefferies etc were all there and he demolished them all with his new lipo chassied 416X. He is saving...
Forum: Electric On-Road
04-21-2010, 08:19 AM
Replies: 2,947
Views: 426,588
Posted By blue247carz

Think we may have solved the problem with esc...

Think we may have solved the problem with esc going dead before start, Ashley Wiffen has found something about it on the german forum and it translates to this.

On the transmitter tab in the...
Forum: Electric On-Road
04-19-2010, 12:38 PM
Replies: 2,947
Views: 426,588
Posted By blue247carz

Problem with gen 2 esc

Hi guys upgraded from the gen1 GM120 to the gen2 GM120 and upgraded the firmware to 11.1 all is good... the new modes that are pre set seem much better than older profiles. I have been using standard...
Forum: Electric On-Road
03-29-2010, 02:37 PM
Replies: 10,622
Views: 1,517,863
Posted By blue247carz

46mm shafts in front make the car understeer and...

46mm shafts in front make the car understeer and push, this is why the X comes with 44mm shafts. Also is why the X has more steering than the WCE which came with 46mm up front.....
Forum: Electric On-Road
09-01-2009, 01:16 PM
Replies: 2,947
Views: 426,588
Posted By blue247carz

Hey Chris what is the motor that you are having...

Hey Chris what is the motor that you are having probs with?

I have probs running the X12's with GM speedo due to the amount of advanced timing already in the motors, they occasionally cog if I...
Forum: Electric On-Road
07-28-2009, 01:21 PM
Replies: 2,947
Views: 426,588
Posted By blue247carz

Hi Martin, I am running a GM 6.5t with 12.5mm...

Hi Martin, I am running a GM 6.5t with 12.5mm rotor and Lipo on a GM90 esc. The software version is 4.8 and there are people saying that the later software versions give more performance and a better...
Forum: Electric On-Road
06-03-2009, 01:53 PM
Replies: 2,947
Views: 426,588
Posted By blue247carz

Hey Martin hope were all keeping you busy :nod:...

Hey Martin hope were all keeping you busy :nod: good job.

Could you tell me on version 1.3.6 where it has opened up the special tab which has the switching point rpm, and timing 2 & 1 adjustable...
Forum: Electric On-Road
04-06-2009, 02:10 PM
Replies: 2,947
Views: 426,588
Posted By blue247carz

GM 6.5t where to get one?

Hi Martin, talking with a friend recently and he mentioned they have been testing 6.5 lipo over here against 5 cell 6T delta and only found the GM 6.5t comparable on performance, where can I get one...
Forum: Electric On-Road
04-24-2008, 08:33 AM
Replies: 7
Views: 1,192
Posted By blue247carz

Still waiting for them to come into stock at...

Still waiting for them to come into stock at tower hobbies, they are now saying end of April! :mad:

I have managed to get hold of the Nosram version which is the same motor built by LRP.

Tried...
Forum: Electric On-Road
04-08-2008, 11:57 AM
Replies: 19,761
Views: 1,983,942
Posted By blue247carz

It's not the pivot blocks they are all spot on, I...

It's not the pivot blocks they are all spot on, I have been measuring every one I can find and they are all within 0.03mm which could be me!

I Have spoken with Mirage UK who are the distributers...
Showing results 1 to 25 of 47
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.