R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
 
Page 1 of 14
1
2
3
11
Last »
Search: Posts Made By: FRONTI3R
Showing results 1 to 25 of 342
Search took 0.02 seconds.
Forum: Electric Off-Road
03-09-2016, 11:06 AM
Replies: 6,089
Views: 1,599,177
Posted By FRONTI3R

Keep a real close eye on the temp. of that motor....

Keep a real close eye on the temp. of that motor. I found I couldn't fit a small enough pinion to get the heat down enough to run long races. A fan helped
Forum: Electric Off-Road
03-08-2016, 08:12 AM
Replies: 15,110
Views: 2,241,154
Posted By FRONTI3R

By the way... Less Droop in the front does: ...

By the way... Less Droop in the front does:
-Less Rearward Weight Transfer
-Better on Smooth Tracks
-More On-Power Steering
-More Responsive During Direction Changes

You could also go with...
Forum: Electric Off-Road
03-08-2016, 07:48 AM
Replies: 1,169
Views: 301,496
Posted By FRONTI3R

I would go with the LRP 4700kv if I were you. I...

I would go with the LRP 4700kv if I were you. I ran my SL with a 4850kv and it was the perfect speed but was a bit warm since it was a 545 size motor.
Forum: Electric Off-Road
03-08-2016, 04:34 AM
Replies: 15,110
Views: 2,241,154
Posted By FRONTI3R

take a couple mm's of droop out of the front and...

take a couple mm's of droop out of the front and see if that helps keep the front end down on power.
Forum: Electric Off-Road
09-13-2015, 08:08 PM
Replies: 1,169
Views: 301,496
Posted By FRONTI3R

TKR5570-17

TKR5570-17
Forum: Electric Off-Road
09-12-2015, 06:22 PM
Replies: 1,169
Views: 301,496
Posted By FRONTI3R

Wing and mount and body. Front Bumper. The four...

Wing and mount and body. Front Bumper. The four stub shafts and wheel nuts. And the side pods since the SCT410 have those tabs. Oh and rear mud flaps
Forum: Electric Off-Road
09-08-2015, 10:45 AM
Replies: 6,089
Views: 1,599,177
Posted By FRONTI3R

go up one location on your shock tower camber...

go up one location on your shock tower camber links. This will lower your roll centre. Don't forget to reset your camber after you have moved the links up on the tower.
Forum: Electric Off-Road
08-07-2015, 06:04 AM
Replies: 6,089
Views: 1,599,177
Posted By FRONTI3R

Check out the 4th post from "fredswain" here for...

Check out the 4th post from "fredswain" here for that information:

http://www.rctech.net/forum/electric-off-road/519561-tune-camber-links.html
Forum: Electric Off-Road
07-30-2015, 12:38 PM
Replies: 6,089
Views: 1,599,177
Posted By FRONTI3R

Reduce your front droop to have less of that......

Reduce your front droop to have less of that... this truck has lots of travel, that would be good for outdoor racing
Forum: Electric Off-Road
07-30-2015, 10:43 AM
Replies: 26,696
Views: 3,546,230
Posted By FRONTI3R

The conversion kit was discontinued therefore you...

The conversion kit was discontinued therefore you would have to search online.

I personally bought the EB48SL kit and love it.

I also lightened up my SCT410 with the EB chassis, light outdrives...
Forum: Electric Off-Road
07-23-2015, 10:45 AM
Replies: 6,089
Views: 1,599,177
Posted By FRONTI3R

TKR6063 Shock Pistons (CNC, conical, 6×1.5,...

TKR6063 Shock Pistons (CNC, conical, 6×1.5, 10.6mm˛)
Forum: Electric Off-Road
07-15-2015, 08:20 AM
Replies: 1,169
Views: 301,496
Posted By FRONTI3R

Hey Dan, I'm about to install those same...

Hey Dan,
I'm about to install those same electronics in my EB48SL. What size track are you geared for and what pinion are you using?
The track I will be running on is Indoors 120 feet x 80 feet. ...
Forum: Electric Off-Road
05-07-2015, 10:53 AM
Replies: 15,110
Views: 2,241,154
Posted By FRONTI3R

I prefer bullet connectors directly to the...

I prefer bullet connectors directly to the battery. But I didn't have that option two years ago when I got a 4s battery that came with deans connectors. Never had a problem with the deans on it yet.
Forum: Electric Off-Road
04-28-2015, 06:06 AM
Replies: 15,110
Views: 2,241,154
Posted By FRONTI3R

That's all I do. Been doing it for years. Boil...

That's all I do. Been doing it for years. Boil for 15min. on one side then I flip them and boil them another 15min. The drop them in cold water. The tires pull right off the rim. If any glue is...
Forum: Electric Off-Road
04-17-2015, 08:37 AM
Replies: 15,110
Views: 2,241,154
Posted By FRONTI3R

Same here, used velcro. 2.5 years on the same...

Same here, used velcro. 2.5 years on the same body.
Forum: Electric Off-Road
02-27-2015, 08:56 AM
Replies: 26,696
Views: 3,546,230
Posted By FRONTI3R

From the first page first post: ...

From the first page first post:
http://i1341.photobucket.com/albums/o746/marinearmeni/rearouter3_zpsec5d5eca.jpg
Forum: Electric Off-Road
02-27-2015, 07:23 AM
Replies: 26,696
Views: 3,546,230
Posted By FRONTI3R

This was posted in the EB48 thread so keep in...

This was posted in the EB48 thread so keep in mind that the changes effect it's toe. and it's toe is different than the SCT410.
...
Forum: Electric Off-Road
02-17-2015, 06:58 PM
Replies: 26,696
Views: 3,546,230
Posted By FRONTI3R

It is heavier compared for sure. However I don't...

It is heavier compared for sure. However I don't think adding that weight to the back of the truck is all that bad of an idea.
Forum: Electric Off-Road
02-17-2015, 11:56 AM
Replies: 26,696
Views: 3,546,230
Posted By FRONTI3R

-Original Centre Diff motor mount weight: 0.06...

-Original Centre Diff motor mount weight: 0.06 lbs
-Option part Center Diff Rear Support aluminum weight: 0.04 lbs
Total weight of both parts: 0.10 lbs
(Note. that doesn't include the screws)
...
Forum: Electric Off-Road
02-17-2015, 11:09 AM
Replies: 26,696
Views: 3,546,230
Posted By FRONTI3R

I posted this already on the EB48 thread but just...

I posted this already on the EB48 thread but just thought I would point out that the original replacement motor mount...
Forum: Electric Off-Road
02-17-2015, 11:04 AM
Replies: 15,110
Views: 2,241,154
Posted By FRONTI3R

Considering that the option motor mount...

Considering that the option motor mount (http://www.teknorc.com/shop/tkr5210x-center-diff-motor-mount-7075-gun-metal-anodized-lightened/) is $48 and the option aluminum rear support...
Forum: Electric Off-Road
02-13-2015, 11:14 AM
Replies: 26,696
Views: 3,546,230
Posted By FRONTI3R

I don't see it as a tuning option for myself,...

I don't see it as a tuning option for myself, considering how badly the +3mm wheels caused the tires to get eaten up on the SC body. Tires are not cheap!
(unless you cut a bunch of plastic off the...
Forum: Electric Off-Road
02-13-2015, 10:03 AM
Replies: 26,696
Views: 3,546,230
Posted By FRONTI3R

+3mm wheels for the AE will be too wide on the...

+3mm wheels for the AE will be too wide on the SCT410, the tires will rub on the body and wreck the outside tread of your tires. Also it won't be ROAR legal... in case you race with ROAR rules.
Forum: Electric Off-Road
02-09-2015, 12:31 PM
Replies: 26,696
Views: 3,546,230
Posted By FRONTI3R

-Aluminum Servo Horn (Durability) -Rear Angled...

-Aluminum Servo Horn (Durability)
-Rear Angled gearbox TKR5016B (Durability)
-Springs, one set softer & Harder (setup)
-shock pistons - 6x1.5 (recent update most drivers use) I like the 8x1.4...
Forum: Electric Off-Road
01-02-2015, 12:27 PM
Replies: 26,696
Views: 3,546,230
Posted By FRONTI3R

Did you take the cover off the servo and look...

Did you take the cover off the servo and look inside?

I had that same issue with this servo... I guess it was forced too far at some point and it broke some little plastic end point tabs on the...
Showing results 1 to 25 of 342
 
Page 1 of 14
1
2
3
11
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.