R/C Tech Forums - Search Results

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Community
Wiki Posts
Search
 
Search: Posts Made By: HenryC
Showing results 1 to 25 of 221
Search took 0.02 seconds.
12-05-2023, 05:31 PM
Replies: 185
Views: 34,237
Posted By HenryC

Looks like the track is not as fast as during the...

Looks like the track is not as fast as during the Worlds warmup. Ollie Payne ran a good bit faster then (same track layout). ...
10-30-2023, 05:02 PM
Replies: 15,683
Views: 2,322,576
Posted By HenryC

Sky RC Cups fit, but it is a very tight fit.

Sky RC Cups fit, but it is a very tight fit.
09-20-2023, 10:01 AM
Replies: 98
Views: 8,427
Posted By HenryC

I have only tuned a few motors so still learning....

I have only tuned a few motors so still learning. I have also noticed significant improvement in the rotor asymmetry after shimming so that the rotor is a little closer to the Hall effect sensors...
09-01-2023, 02:58 PM
Replies: 98
Views: 8,427
Posted By HenryC

XT60

XT60
08-15-2023, 05:23 PM
Replies: 48
Views: 4,224
Posted By HenryC

I just bought one of his "Load Master" units...

I just bought one of his "Load Master" units (just the unit that holds the motor under test and the load motor along with the resistor loads). As a retired engineer, I have to say I am impressed with...
06-13-2023, 11:39 AM
Replies: 1,417
Views: 396,586
Posted By HenryC

I just got a slot machine 25.5 Certified Plus...

I just got a slot machine 25.5 Certified Plus motor. First thing I did was put it on my HW Tunalyzer. I know the values between the Tunalyzer and Motorlyser Trinity uses to measure performance will...
05-15-2023, 01:32 PM
Replies: 12,117
Views: 2,394,818
Posted By HenryC

BWOAH! Ultra Light body???

I see Zoo Racing has come out with an ultra light version of the BWOAH! body. Where would this be used? Certainly not in USGT as it requires the body to weigh at least 95g (if not extra weight must...
03-07-2023, 08:13 AM
Replies: 12,117
Views: 2,394,818
Posted By HenryC

This has always worked well for me. I have had...

This has always worked well for me. I have had one of these for over 20 years. Only $7

Compass circle cutter...
10-08-2022, 12:45 PM
Replies: 2,383
Views: 593,439
Posted By HenryC

I have heard that with HobbyWing motors you can...

I have heard that with HobbyWing motors you can route the ESC wire under the motor. For the Trinity motors I use, there is not enough clearance under the motor so I route it over the motor.
09-30-2022, 08:34 AM
Replies: 12,117
Views: 2,394,818
Posted By HenryC

Not sure what this photo would tell you. It is...

Not sure what this photo would tell you. It is mounted on a box stock T4'21 in this picture. I used horizontal body posts for mounting the rear. Otherwise the rear vertical body posts will be right...
09-29-2022, 02:15 PM
Replies: 12,117
Views: 2,394,818
Posted By HenryC

I thought the T4'21 came with ultra low shock...

I thought the T4'21 came with ultra low shock towers. I had no problem mounting the BWOAH! on my T4'21 as well as X4.
05-26-2022, 11:15 AM
Replies: 0
Views: 373
Posted By HenryC

XRAY T4'21

T4’21 graphite version, good condition
Aluminum steering arms
Graphite fixed pullies
Low friction belts
Graphite bumper upper holder brace
Manual

Extra parts/tuning parts:
Graphite bumper...
01-11-2022, 05:44 PM
Replies: 2,383
Views: 593,439
Posted By HenryC

So far I have been very happy with the X4. No...

So far I have been very happy with the X4. No parts broken until this last Saturday. I hard hit broke the top deck at the thin part just prior to the rear portion. Since I did not have another on...
12-10-2021, 07:19 AM
Replies: 637
Views: 121,551
Posted By HenryC

Going back to the question I asked, how many of...

Going back to the question I asked, how many of the people here complaining about Florida clubs running foams in GT12 run SJT rubber tires outside on asphalt? If any, how well do they work on asphalt...
12-09-2021, 12:59 PM
Replies: 637
Views: 121,551
Posted By HenryC

The problem with running SJT tires is the all but...

The problem with running SJT tires is the all but one of the Florida tracks are outside on asphalt. How well and how long would SJT tires last on asphalt? I would have no problem running SJT tires if...
11-17-2021, 05:04 PM
Replies: 6
Views: 2,456
Posted By HenryC

I have been running 57/80 in my T4'21 for USGT. I...

I have been running 57/80 in my T4'21 for USGT. I did a little dremel work on the top deck to get the 57 pinion to fit on the X4.
11-11-2021, 02:35 PM
Replies: 12,117
Views: 2,394,818
Posted By HenryC

Very good advice. Been there. I also make my...

Very good advice. Been there. I also make my battery leads so they cannot be plugged in backwards but still got stung when I had a new battery that has jacks on top and bottom. I hate that sound and...
11-09-2021, 05:14 AM
Replies: 14
Views: 2,025
Posted By HenryC

Adding photo of bottom of chassis. It was run on...

Adding photo of bottom of chassis. It was run on asphalt so it has scratches. I replaced the chassis this summer and it has 4 race weekends on it.
...
11-08-2021, 07:09 AM
Replies: 14
Views: 2,025
Posted By HenryC

ttt

ttt
11-07-2021, 08:06 AM
Replies: 14
Views: 2,025
Posted By HenryC

ttt

ttt
11-06-2021, 08:05 AM
Replies: 14
Views: 2,025
Posted By HenryC

ttt

ttt
11-05-2021, 08:20 AM
Replies: 14
Views: 2,025
Posted By HenryC

ttt

ttt
11-04-2021, 08:42 AM
Replies: 14
Views: 2,025
Posted By HenryC

ttt

ttt
11-03-2021, 01:17 PM
Replies: 2,383
Views: 593,439
Posted By HenryC

I like that the X4 does not require taking the...

I like that the X4 does not require taking the top deck off to change the spur gear. So far I have only figured 2 ways to change the pinion; remove the top deck or use a small L shaped allen wench to...
11-03-2021, 07:49 AM
Replies: 14
Views: 2,025
Posted By HenryC

ttt

ttt
Showing results 1 to 25 of 221
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.