R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
Search: Posts Made By: akirahz
Showing results 1 to 25 of 25
Search took 0.00 seconds.
Forum: Nitro On-Road
06-14-2011, 12:20 PM
Replies: 20
Views: 17,896
Posted By akirahz

Thumbs up Okay looks like that was the problem, the yellow...

Okay looks like that was the problem, the yellow fuel line going into the pipe was way to far up the pipe, there was about 3 to 4 inches worth of fuel tubing stuffed down into the exhaust pipe.

I...
Forum: Nitro On-Road
06-14-2011, 06:00 AM
Replies: 20
Views: 17,896
Posted By akirahz

Ah okay thanks itchy Well i think i found my...

Ah okay thanks itchy

Well i think i found my problem.. i think it is the fuel.. my tuned pipe is strange to me.. its like its been welded together by someone, and it has a hole punched in it where...
Forum: Nitro On-Road
06-14-2011, 04:03 AM
Replies: 20
Views: 17,896
Posted By akirahz

The idle airgap?? The airgap on throttle is...

The idle airgap??

The airgap on throttle is wide open i guess, on idle is about 1mm to 1.5mm it seems to idle good on both around those measurements.

Saliva does not boil off, even after...
Forum: Nitro On-Road
06-14-2011, 04:02 AM
Replies: 20
Views: 17,896
Posted By akirahz

How do i check pressure in the fuel tank? I...

How do i check pressure in the fuel tank?

I set the engine back to factory but its still a no go

then again, im not sure what they mean by turns, if they means turn the needle 180 degrees or a...
Forum: Nitro On-Road
06-13-2011, 09:40 PM
Replies: 20
Views: 17,896
Posted By akirahz

Well i cant get the engine to run good at all...

Well i cant get the engine to run good at all now, i can get it started, but every time i give it the gas it flames out, no matter what tuning i do to it, and some times if i mess with the engine or...
Forum: Nitro On-Road
06-13-2011, 12:29 AM
Replies: 20
Views: 17,896
Posted By akirahz

Pretty sure the igniter is fully charged, i dont...

Pretty sure the igniter is fully charged, i dont know what the engine temp is i dont have a gauge yet. The GP is dry and not very sooty or anything, its pretty clean actually but it doesnt glow as...
Forum: Nitro On-Road
06-12-2011, 01:53 AM
Replies: 20
Views: 17,896
Posted By akirahz

AH! ive watched a ton of ali's videos, hes a real...

AH! ive watched a ton of ali's videos, hes a real informative guy

I think i found out one of my main problems.. my glow plug went bad on me, at full throttle it was just shutting off, but today it...
Forum: Micro and Mini Scales
06-10-2011, 07:03 PM
Replies: 4
Views: 1,764
Posted By akirahz

Dang! I had it for 1 day and this happend to it...

Dang! I had it for 1 day and this happend to it without hardly any rough handling at all.. and my local hobby shop doesnt carry this servo.. guess i'll have to order one
Forum: RC Flight
06-10-2011, 06:51 PM
Replies: 3
Views: 1,053
Posted By akirahz

haha, i like your enthusiasm! Yeah I would like...

haha, i like your enthusiasm! Yeah I would like to try building one though but was curious how difficult it is or how many man hours it takes to build one. My father used to build them In the 70s and...
Forum: Nitro On-Road
06-10-2011, 06:22 PM
Replies: 20
Views: 17,896
Posted By akirahz

Ok thanks guys for the assessment and especially...

Ok thanks guys for the assessment and especially thank you for the needle identification for the carb.

The front window does have a large round hole in it, and there is a hole in the back of the...
Forum: Nitro On-Road
06-09-2011, 08:30 PM
Replies: 20
Views: 17,896
Posted By akirahz

Engine over heating? Or sometimes shuts off at full throttle

I'm having a tuning dilemma here, after a few runs some times my car will just shut off at or around idle speed, i noticed the engine was very hot.. so i decided to quit running it for now till i can...
Forum: Nitro On-Road
06-09-2011, 08:23 PM
Replies: 7
Views: 2,223
Posted By akirahz

Ah thank you for the reply good sir! It...

Ah thank you for the reply good sir!

It seems to be much better now after adjusting the horn, this should work till i can replace the throttle linkage, i did quite a few passes and it never came...
Forum: Nitro On-Road
06-09-2011, 03:03 AM
Replies: 7
Views: 2,223
Posted By akirahz

Okay i will try adjusting the plasic pivot, as it...

Okay i will try adjusting the plasic pivot, as it is loose and can swing all over the place, perhaps it should be tight?

I dont know what collets are? do you mean the two black screws that are on...
Forum: Nitro On-Road
06-08-2011, 06:54 PM
Replies: 7
Views: 2,223
Posted By akirahz

AH okay, so i gota replace a part.. darn.. well...

AH okay, so i gota replace a part.. darn.. well do u know if they make a metal one so i dont have to deal with anymore plastic in that area?

i was told the throttle linkage is brand new though,...
Forum: Nitro On-Road
06-08-2011, 06:01 PM
Replies: 7
Views: 2,223
Posted By akirahz

Slide carb throttle arm comes loose?

Im havin a problem with my throttle linkage coming loose from the slide carb on my TA NTC3. The engine is a RB .12 but im not sure of the exact model. The throttle linkage has a plastic ball on it...
Forum: Micro and Mini Scales
06-08-2011, 06:01 PM
Replies: 4
Views: 1,764
Posted By akirahz

1/36 Micro Losi Stadium Truck Steering Servo?

My steering servo on this truck is acting strange, some times it steers fine left and right, and other times it like locks up and wont move left or right at all, even by physical force.. i checked...
Forum: RC Flight
06-08-2011, 06:00 PM
Replies: 3
Views: 1,053
Posted By akirahz

Questions about starting RC Air/Heli hobby

Do you need to be really good with aeronautics to build your own RC Heli or RC Plane kit? Cause i don't really know much about actual aeronautics or balancing or anything like that. I'm not a pilot...
Forum: R/C Tech Site Forum
06-08-2011, 05:57 PM
Replies: 57
Views: 8,465
Posted By akirahz

This should be a sticky, i was wondering as well...

This should be a sticky, i was wondering as well how many posts it took to put up a pic, thanks! :)
Forum: Rookie Zone
05-25-2011, 02:44 PM
Replies: 4
Views: 1,094
Posted By akirahz

Ok thanks guys! im having some trouble with...

Ok thanks guys!

im having some trouble with my other RC Truck, i finally got the engine going with some tuning, but the servos twitch on their own .. and just a while ago, it took off on me at...
Forum: Rookie Zone
05-24-2011, 05:21 PM
Replies: 4
Views: 1,094
Posted By akirahz

What radio/transmitter do i need for this car?

Hi, i recently picked up a Team Associated NTC3 that has been rebuilt from the ground up pretty much.

But it doesnt have a transmitter or reciever

would it be okay to get a 2 chan transmitter...
Forum: Nitro Off-Road
05-23-2011, 05:10 PM
Replies: 9
Views: 3,412
Posted By akirahz

Ok, im going to give that a try, should i also...

Ok, im going to give that a try, should i also remove the air filter when i tip the car over and turn the motor over or is it okay to leave it on?
Forum: Nitro Off-Road
05-23-2011, 02:34 PM
Replies: 9
Views: 3,412
Posted By akirahz

Ah thank you, that would be terrific.. if i can...

Ah thank you, that would be terrific.. if i can just get the thing started now haha

i bought some brand new fuel, its some blue 20% traxxas stuff, so i drained out all the old fuel and now im...
Forum: Nitro Off-Road
05-23-2011, 01:56 PM
Replies: 9
Views: 3,412
Posted By akirahz

yeah thats the truck right there

yeah thats the truck right there
Forum: Nitro Off-Road
05-23-2011, 11:40 AM
Replies: 9
Views: 3,412
Posted By akirahz

ah thanks for the reply, ive been doing some...

ah thanks for the reply, ive been doing some research on exactly how these drive train systems work and what not, and im pretty sure mine is centered so it probably wont move.. But after doing a...
Forum: Nitro Off-Road
05-23-2011, 12:14 AM
Replies: 9
Views: 3,412
Posted By akirahz

Nitro Off Road Truck - Front Differential Broke - Will it move?

I recently traded a friend of mine some computer parts for his old nitro off road truck, it was 4wd but he said the front differential was busted.. so we gutted the front diff and took the metal...
Showing results 1 to 25 of 25


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.