|
Originally Posted by JayL
(Post 13611624)
It's not a rumor. People I trust, that were there, told me and showed pics. I'm just trying to figure out if it was a single one defect. Futaba tends to hide things like the 603fs overheating issue...
Futaba is not a small brand. They have a bit of an idea of what they're doing :) |
No clue whether the 4PX has any issues, but as JayL said Futaba does have a history of denial with at least one issue (i.e. the original surface FASST recievers over heating). I wouldn't completely dismiss report(s) of issues just because Futaba is big company that has been around a long time...
|
Didn't they update the 603 after they discovered the over heating issue ?
|
What's everybody using as a case?
|
4pksr case
|
Originally Posted by Sroufe7
(Post 13608795)
My radio should be here on Thursday, ordered it from Tower with the coupon and it came to I believe $430.
|
Originally Posted by kcobra
(Post 13608829)
Damn, what coupon code did you use? The best I could find in my email was a Gold coupon that was $80 off $500-$624.99 purchase. So $470 after coupon. Amain is $30 higher when you factor in the $40 coupon and ~$10 in Amain bucks you earn with the purchase. I did a bit of an impulse buy and order from Amain just now.
|
Right now tower is running a special for club members . $540 for the radio - $80 coupon code plus $36 in e-cash. That gets th radio down to $424 . Pretty cheap . I'm still torn between the 4px and m12 .
|
I got a question for everyone. I have two LRP flow esc's that the buttons are stuck on and I cant recalibate them. They work perfectly fine and LRP want $137 a piece to repair/replace them so its basically pointless to get them repaired.
I have a 4pl now and my son has a 3pl and I can bind either of these radios to the bad button esc's and the end point calibration is correct for both radios. I would like to get the 4PX but I don't want to have to replace two ESC's at the same time. So is the calibration end points coming from the receiver or the radio? Do you think if I just leave the current recievers in the cars the endpoints will be the same between the 4pl and 4PX? This would buy me some time on getting new esc's. |
Originally Posted by skrib21
(Post 13614759)
Right now tower is running a special for club members . $540 for the radio - $80 coupon code plus $36 in e-cash. That gets th radio down to $424 . Pretty cheap . I'm still torn between the 4px and m12 .
|
Originally Posted by skrib21
(Post 13614759)
Right now tower is running a special for club members . $540 for the radio - $80 coupon code plus $36 in e-cash. That gets th radio down to $424 . Pretty cheap . I'm still torn between the 4px and m12 .
|
|
Not bad, use your e-cash to buy a R204GF-E receiver for your 4PX.
|
|
Originally Posted by ufoDziner
(Post 13614883)
I see the radio as $549.99 ($550), and am only seeing a $75 coupon for me. :-/ Where is the e-cash part? So, I see it as $440 if I can find the e-cash. Still a good deal, but not $424.
Anyone have any insight to my calibration question? I would like to get this radio while its in stock and cheap but I don't want to spend another $400 on replacing working esc's. |
| All times are GMT -7. It is currently 12:56 AM. |
Powered By: vBulletin v3.9.3.9 Patch Level 3
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.