Originally Posted by Bigbearfin (Post 14122705)

Can you confirm this. That 80 degrees sounds like mad timing anyway :)

How much timing you use with tekin 4 pole motors and how much timing motors like Hobbywing 4pole 4700kv motor?

Originally Posted by Randy_Pike (Post 14119251)

You can't install a "Y" connector. A trick I use from time to time is a thin piece of tape on the connector about 3/4" long to use as a "handle" on the connector. I don't make a ton of adjustments since I know what I like, but during testing I do this.

I've also seen guys use shrink wrap to grab the part of the connector that sticks out to "stiffen" the program and fan harness a bit again to aid in grabbing it.

Did you get the Android App and Hotwire to work?

Originally Posted by Bigbearfin (Post 14121763)

Hi Randy!

Could you explain me how timing advance works in RX8.
TP1: 0* Timing Advance
TP2: 20* Timing Advance / RPM Range 5443-20,016
TP3: 40* Timing Advance / RPM Range 5443-20,016
TP4: 60* Timing Advance / RPM Range 5443-20,016
TP5: 80* Timing Advance / RPM Range 5443-20,016

Is it so that timing advance starts from 5443 rpm and continues to 20016? What if I use motor that revs 40k? Whats the point to set timing back to normal when motor is higher than 20016rpm?

OR is that so that timing is 0 degrees from 0 to 5443 rpm and then timing will increase to xx* degrees linearly and reached xx* at 20016rpm and then stays there?

Originally Posted by qstorm777 (Post 14122956)

Can you have a y coming out of the receiver, one end connected to the RX8 and the other for hotwire?

Originally Posted by ncamara (Post 14127504)

What is the size of the screws used to hold down the fan to the case?

Originally Posted by Tekin Prez (Post 12233704)

Many places should have product arriving and checked in next week. There are a lot of backorders so hard to say if any will show as in stock right away.

We do intend to add an export feature for the data logs. Likely a CSV file and you can have all the fun you want with it. We need to finalize a few more things before we commit to a standard format for the data.

Originally Posted by bcane98 (Post 14142829)

Anyone ever have the switch never work in the OFF position? Basically when I plug the battery in, the switch is in the OFF position, and the system turns ON... turn it to ON, then to OFF, still stays on.

Originally Posted by bcane98 (Post 14142829)

Anyone ever have the switch never work in the OFF position? Basically when I plug the battery in, the switch is in the OFF position, and the system turns ON... turn it to ON, then to OFF, still stays on.

Originally Posted by fizzy (Post 14145448)

Hi, I'm looking at buying a Tekin rx8 gen2 and I was wanting to switch it out to the black case, can anyone tell me if this is a simple straight forward swap or what would be involved
Thanks

Originally Posted by PDN2000 (Post 14142499)

Hello Tekin Prez,
Long time ago, in june 2013, you wrote the quoted message above. In that time it was the introduction of version 2.38 of Hotwire software. The actual version of that software is 2.5 and the capability to export data is not there. It seems that you talk somehow with the authority of Tekin, then my question is very simple: Has Tekin the intention to introduce that capability in the Hotwire SW and by when? Many thanks for your replay.