cn-us
 

is it possible to go from CN to US?

Hi Mike,
New to the iT4 but not to R/C TECH. Just bringing myself up to date on the issue with this radio. Is there any contact info for flysky jerry in this thread? I've seen the post over on ultimate rc but not in here. Any help greatly appreciated, John.

Here is the email I used.

[email protected]

After the chip swap mine is working great. Wonder how long until the new stock is out there?


Buzz.

Thanks Buzz....:) I'll get on the horn with him today and see if I can get one....eventually!

Should be a little faster if Jerry has caught up on all of the request for the chip.


Buzz.

Hi guys anyone know if this "latest 2nd gen" version is the one with the updated chip? I need to buy the tx but don't have the skills to solder...

http://www.ebay.com/itm/Latest-FLYSK...item1c3612812e

Best you might be able to do is ask them to tell you the info from the radio. Then ask Jerry if he can tell you the build date and see if it has the new chip.

You could ask them the same thing about this radio. Ask for a serial number, then ask Jerry if he can tell you the build date?


Buzz.

http://www.hobbypartz.com/79p-it4-to...-titanium.html

The recievers are not as cheap as the 3gtb receivers. But they are around 16-20$ I bought 3 from eBay shipped for 44$. However I was disappointed with end results. You have to bind each receiver every time you use it. Unlike the 3gtb you can power on and go

Anyone know if there is a FlySky surface radio that supports 433mhz operation? I'm working on a project that will need more range that a typical radio provides. I am finding a lot of stick radios that can do it, but no pistol grip stuff.

I just bought the fs-it4 but haven't had much time to play with it, however I also bought 3 xtra receivers. The biggest complaint I have is I mounted 4 receivers in 4 cars and I have to bind each receiver every time unlike the 3gtb. Other than that I haven't played with it enough. The sensors will not recognize on my controller but I don't really care about using them

Needs a new chip, as per past posts

FYI - I asked jerry about ETA for new it4s with upgraded chips/firmware- his reply:

Very glad you are interested in our iT4.
About two or three weeks later you can buy latest it4 in Hobbypartz or ebay.

Best Regards,

JY

skype: jerry_flysky
TEL: 086-1866 5882 728
SHENZHEN COLCO INDUST DEVELOPMENT CO. LTD.
FLYSKY RC MODEL Co.,Ltd

Quite interesting. The Flysky iT4 and Absima CR4T share the same electronics and I suppose that Flysky makes the radios for Absima. Why then the Absima has the multiple rx binding issue allready fixed (from the start of the year), while the Flysky says "About two or three weeks later you can buy latest it4...". Need to empty the stock? ;)

Thanks Littlebuddha, I will be ordering 2 set of the iT4 with the upgraded chips and firmware + 6 Rx's when in stock from HobbyPartz.

I bought this radio 2 months ago @ hobby partz when can get new chip? Hate binding every car. Any input kindly appreciated