LOL

That was one of the most funny posts I have seen in a long time. I read it 3 times to make sure I wasn't adding it in on my own. Haha!

haha.... glad i could bring a laugh or two to the thread.. after all we do need some chit chat in a tech thread for it to be rctech. :lol:

I know i'm most likely going to get biased opinions on this thread, but was hoping if someone who has used both the LRP X12 13.5 and the ViperRC 13.5 could give an honest comparo between the two?

TIA

Cheers
John

My friend had an LrP 13.5. It was easily slower than any other 13.5 we tested. Murffdog, Tekin, Viper, Orion. And it got hot,..

I will say-the Murffgod was the fastest out of the box, but the Viper can handle so many different combinations of timing and gearing that it was easily made my choice of motor. It runs cool, cn be over geared, to get it out if it's super high torque and not sweat at all

Viper the way baby

Sounds like I need to switch motors, while I like my Orions and Peaks ALOT, I feel there has to be a better solutions then them. How do they match up to Orions? Peaks? pricewise? I havent done any digging, just logged on, have a "new RT5" that im in the process of rebuilding.

are we talking boosted or non-boosted?

I'll be there running e-buggy, Only have 1 Viper prototype motor and it's a 2450

hey weylin

i sent you a email the other day and you might have missed it again

charlie
[email protected]

lota good info on here,thanx guys! just pulled the trigger on a 17.5,i hope its better than my novak for my xxx-sct 2wd. any good gearing on a somewhat tight carpet track,right now im running,21-88.......thanx!

gear it to the moon :D

I have been running a 9.5 FDR and it seems ok. I have been doing lots of testing with this motor and so far I don't like the power band. I have gone back to the ballistic. But I would try the 9.5 to 9.2 FDR. I am also running about 15* of dynamic timing in the speed control. If you are running with zero timing I would be closer to 8 for FDR. The motor I got does not exhibit the characteristics that people on here describe. It's just slow. And really does not have more torque than a ballistic.

You can pick them up from $80 to $90, and your best bet would be amain hobbies, unless your lhs can get them for you.

Any news on the 1/8th scale stuff?

+1