FH3 Modulation.

If you have a digital servo you can set it to SHR

Leave the ESC at NOR

Got it ty. :)

I set my St to SHR. ESC, 3rd, and 4th channel are set to NOR.

just got an m11x..the manual says the rx input is up to 6V only.. but on the airtronics web it says 4.8V to 7.4V.. has anyone tried using more than 6V?

Looking for alum case and cheapest lipo pack for the m11x. Whats out there?

Ok so i got my radio last night opened it up everything fantastic BUT no charger ,so i got my friend who ordered this for me to call airtronics about the missing charger and they said that there has been a few radios that they fforgot to put them in :rolleyes: and that my charger is on the way so if anyone is missing the charger just call airtronics they will look after you i think.

My shipment from amain included a charger taped to the outside of the box :)

Which model rx? Perhaps you got old stock?

I changed my servos to SHR last night and tried it out today. It may be placebo affect, but it certainly feels like the radio is reacting faster to my inputs.

I also e-mailed Airtronics and they confirmed a 2 cell rx lipo can be used unregulated. This is with the included 92744 receiver that comes with the M11X.


Specifications:

Model: 92744
Frequency: 2.4GHz FHSS-3
Input Voltage (Nominal): 4.8v - 7.4v (4 and 5 cell Ni-MH and Ni-Cd packs to 2-cell Li-PO)
Weight: .3oz (8.5g)
Dimensions: 1.43 x .94 x .59 in (36.5 x 24 x15 mm)
Fail Safe Limit: 3.8v Default - 3.5v to 5.0v adjustable

I was just going to post on the same thing lol. I just got my 92451 and online it says up to 7.4, the manual says only 6.0 max though. Why haven't they updated the manual? It must just be a typo, so 7.4 should be good in the 92451 at least. I haven't tried the other one yet but I guess that can go 7.4 as well.

it's the 451r...

i also have lost the reverse on my HW esc (150A)...i have also checked the setting ..it's for/rev/brake.....it was working before..with my dx3s...

it's the 451r...
will not work with 2s lipo mine went in smoke :flaming:after 10sec about six monce a go I think its new rx that compatible wont let me post a link. Amainhobby has them in stock its like $124

You neeed to rebind the remote and receiver after switching to HRS mode otherwise you are still in normal mode, and SHR will not work with all digital servos. I have a Sanwa m11x with the 451r receiver and my futaba s9551 works in normal mode. But if i switch it to hrs and then rebind the remote and receiver the servo does not operate at all.

does anyone know if this would fit into the m11x?

http://www.rcboca.com/venom-3s-1p-30...k-m11-mx3.html

Thats for the M11 not the M11x. M11x needs a 2s lipo.