Fits perfect right down middle there is room on each side.Lenght is right on

Thanks , been looking for more capacity as well ....

I’m having the same problem “not able to change what model I am on”, looks really strange.

I’m receiving the following message “DISPLAY MODE ONLY”

By the way, the button "Display Switch" isn’t work for nothing.

Please, help :)

Best Regards
Robert

Are you holding the display switch for 2 seconds?

Hello all. I am considering the m11x but does anyone know if the new receivers can handle 7.4 volts?

Model Select
 

Yes, more than 2 seconds, Im really concerned about this issue.

Regards
RB

what are the dimensions of the battery pack that can fit?
will a flat reciever pack (size of a 5 cell flat pack) fit in this radio?

Differences between new M11X & M11
 

Can anybody who had bought M11X tell me what differences are between new M11X and M11?

How about steering & throttle speed, exponential, adjustable rate control, anti-lock braking and traction control setups? Are these same as previous model M11?

Thank you.

It is faster on response you can really tell when using digital servos with SHR mode.

Did you figure it out? Mine is stuck on that mode as well.

Ok I guess you have to have the unit off, then hold the Display button which will then allow you to basically change models and edit settings.

Kind of stupid.

Man this radio is Marsupial fast...........:lol: any bob and tom fans know what I am talking about?

I just talked to Farrell at Airtronics today and was told that the M11x reciever will NOT handle 7.4 volts from a 2 cell LiPo so you have to run a regulator.

Question: I have the Losi 3 cell 11.1 lipo 2400 mah for the M11. I know I cannot run it in the M11x but...Is there a regulator out there that will cut down the 11.1 to 7-9 volts?

Drove my new m11x tonight and WOW! The speed and feel of this radio is incredible! :nod:

2 channel operation
 

Can the radio be put into 2 channel operation with the included receiver. Everytime I try to do it, it wants to go to 2 channel fh2, not fh3. I'm trying to simplify the menus a bit by truning off the other 2 unused channels.

Do anyone know the M11X maximum input voltage ?

Thanks