|
Originally Posted by Roelof
(Post 16134883)
Not sure if the Flysky supports SSR but I did see SR was mentioned.
SSR has a 384 Hz frequency but the center pulse width is 300 usec while all normal servo's have a 1.5 msec center pulse width. SR is using a 760 usec center pulse width and can handle up to 833 Hz. |
Originally Posted by jnyrcr
(Post 16143210)
I believe the speed is the same for both of them.
|
Just purchased an NB4+ and looking into case options as I am currently just using the box and hate adjusting the wheel and removing the battery to put it in the box.
What is everyone using? Would prefer a soft sided case but hard side would work as well. |
Originally Posted by rc864
(Post 16144911)
Just purchased an NB4+ and looking into case options as I am currently just using the box and hate adjusting the wheel and removing the battery to put it in the box.
What is everyone using? Would prefer a soft sided case but hard side would work as well. |
Originally Posted by jonski
(Post 16144914)
I am using a Harbor Freight Apache case.
thats what im using also, i sized up a little bit and im putting my charger and my blue tooth esc stuff and charge leads in it also |
Originally Posted by hippo_408
(Post 16145143)
thats what im using also, i sized up a little bit and im putting my charger and my blue tooth esc stuff and charge leads in it also
|
Went the the Harbor Freight 2800 Apache box. Hard to beat with current sale price if $19.99!
https://cimg9.ibsrv.net/gimg/www.rct...8f6e4bb08.jpeg |
That is what I have as well.
https://cimg6.ibsrv.net/gimg/www.rct...f0b1588b3.jpeg https://cimg7.ibsrv.net/gimg/www.rct...25f1792c3.jpeg |
Nice looking set up as well!
|
Originally Posted by jonski
(Post 16145148)
I forgot to look to see which model I do have, but it is a bit bigger and I have a spot for the wireless charger, my Hobbywing programmer and a small container with some cords and bluetooth module.
|
Originally Posted by rc864
(Post 16144911)
Just purchased an NB4+ and looking into case options as I am currently just using the box and hate adjusting the wheel and removing the battery to put it in the box.
What is everyone using? Would prefer a soft sided case but hard side would work as well. |
We have a Noble 4 that my son uses for racing as well as to run his bashers. Yesterday we were outside using his TT02 on the street and we kept getting a signal loss with the FGr4P receiver. The car was no more than 100' from us. At the same time I was running my car with an old Futaba 4PKS and Fast receiver.. and I could go all the way down to nearly losing site of the car without any issues.
So I brought in his car and I had removed his FGr4P receiver. I usually fold the arial, so I removed the shrink wrap and installed it vertical with an antenna tube. We went back out and the same thing happened again. So I am thinking potentially bad receiver? |
A friend upgraded to the NB4+ and offered me an original NB4. What are the main advantages that the NB4+ offers over the standard unit?
|
Originally Posted by NutDriver
(Post 16147024)
A friend upgraded to the NB4+ and offered me an original NB4. What are the main advantages that the NB4+ offers over the standard unit?
https://www.rctech.net/forum/showpos...postcount=1755 for all the differences |
For throttle / brake endpoints, is there a difference between setting it -100/100 vs -120/120?
|
| All times are GMT -7. It is currently 07:20 AM. |
Powered By: vBulletin v3.9.3.9 Patch Level 3
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.