Hows the rear bearing look?

Something was definately rearing its ugly head into the boost port.

new engine time.....

why nt try from sts dragon p/s 3 port? i use it for my v12 and it run very well,even my novamega 12 using the sts dragon 5port and my novamega sx21 using caster racing,its much cheaper..just suggestion..

Rear bearing looks good! here's a couple of pics

I send an email yesterday and this morning got a response! great customer service! I'm considering letting Uriah modify this motor if I decide to buy new P/S set.

I tried swaping pistons with the V12 unfortunatly they are not the same. V12 piston won't even fit inside the R3 sleeve.

That's not a bad idea since the motor wasn't very old. A new P/S, Uriah's mods and you have a killer motor for a bit less than buying an all new one outright.

that may not a bad idea

Oh I know! it was actually my idea since I have the V12 just laying around...

Well the cranckcase, carb., P/S, crankshafts are very different between V12 and R3 I just figure I would be able to change pistons since they are both RB engines. To my surprice the R3 piston is slightly smaller than the V12

Check out this vid of an RB R3 Murnan Modified engine

http://www.youtube.com/watch?v=8huEwfLEI8E

Engine sent to RBMODS for inspection and Modification!

Hello everyone! Just wanted to share some pics of my R3 modified by Rick Brake! he really hooked me up, let's just say I paid less than if I had purchased a new P/S set.

He installed a new 5 port novarossi Piston and Sleeve, new front bearing, modified crankshaft, sleeve.