Thanks. What plug and head shimming do you guys run. I will be running 25% fuel.

NEED help ....

This weekend at the Texas Biggie I had a Max SL3 implode, so I put in my back up which is a Novarossi NSR3 Race ... I got it new a couple years ago but it has only had MAYBE a half gallon thru it ... After putting it in the car and tuning a little (hadn't been started or ran in about a year) it ran surprisingly well. I continued tuning it, getting the gearing, and clutch / two-speed adjusted. It was running better than it did when I replaced it with the Max.

In the main here's were the problem was, which was why I replaced it to begin with. It runs great, never gets about 270ish. However when I come in to pit an refuel it will flamout ... not everytime and not as soon as the idle slows. It happened twice in the 30 min main, first time (about the 10 min. mark) my pit man refueled me and I left pit lane and on the second turn it just flamed out. It fired right back up with no problem. The second time (about the 25 min mark) after getting refueled I was at the end of pit lane when it flamed out. Once again it started without any problem.

..... Can someone tell me what causes this .....

Swauger joins NOVAROSSI
 

from Novarossi :sneaky::sneaky::nod:

http://www.novarossi.com/content_uk/....php?newsid=67

another great racing driver to our already impressive team line-up.
The honours goes to the always super fast Mike Swauger from the USA.

Both parties are looking forward to an great racing season.

My new Nova 353 09 is on its way can't wait to break in this weekend :nod: this will be my first Novarossi engine ever...:nod::tire::tire:

Ahh, I remember how excited I was before I got my first nova... The good ole' days...

How difficult was break in?

i just got my First Nova at the start of this year, i went on what the rep said on how to break the engine in. i did like 8 tanks on idle temp around 70 degC then i did another 8 tanks slowly leaning it out. probabley a bit excesive but i used the rod for like 3 race meets after and the Rod still hadn't streached. But mine was the 2008 3SCT - Tuned

mitchell

I am looking sooo forward to the Worlds in Lostallo this year, should be awesome.

so the rod is different ?
just i got 2 tuned 08 353's and 3 rods. the part number for the rods are 7602 which by the manual is correct, then the rod in the engines are stamped P1, the rods in the bags are stamped P2 . does anyone know why the number stamped on the rods are different ? cheers .

:confused:

I've never had an issue breaking in a motor. Of course, I did have a hard time breaking in was my first one because it was a pull start. Had blisters for days...:cry:

Those are most likley production control codes

This was announced a while ago: http://www.rctech.net/forum/nitro-ro...novarossi.html

353 header/pipe combo
 

hey guys, could you please tell me what would be the best pipe /header combo for this track using a 353-09,thanks, the strait is about 40 mtrs + sweeper at the end of the strait can be taken almost flat out

rctech.net/forum/attachments/australian-racing/430651d1237415433-moorebank-thread-helles-track-layout-2.jpg

Nova 2630 pipe and get both short and long header.