No longer avail. it was on Ebay new piston and sleeve for $60!

Just bought a btt. I'm wondering what would be a good setup if I threw it into a truggy? Pipe/header/carb restrictor. And what would be a good setup for buggy?

Do you think changing the P5xlt bearings from stock to ceramic would have a major impact on the motor? I am due to change the front bearing as it`s leaking so was considering going for nova rubber seal front and TKO rear ceramic

17011 is the bearing you need.

Anyone?

hey guys,

ive been reading more and more about the bonito being the "GO TO" truggy race engine. i was wondering what the average run time is on one of these engines?

Not sure about truggy but buggy would be 41021 and 2096 for header and pipe. And 7mm insert.

Hi there I run the bonito in my buggy and I get 8 min easily so in a truggy you should get close to 10 min if you drive smoothly on the trigger

not as much as i was hopeing for really. i might just get a locally modded godzilla and save myself the stress. i already have the pip for it.

Hey so I am looking to pick up a new race engine, for my MP9 buggy. I have been thrown for a loop as far as all these new Novarossi motors coming out. Whats good out there? I am coming from a 21-4c team.

Hi guys. Does a long needle carb (#24069) need a different way of tuning approach? Thanks for your help.

plus 4 btt

Keep Off 4, pipe 2096 and manifold 41021 or 41029

Keep Off 7, pipe 9901 and manifold 41021 or 41029

they most certainly do........ I am planning to write you a little explanation of the differences , as you asked this in my thread.... I am nearly caught up in the shop and will have time today to do it...... I would have done it earlier but I have been too backed up with work to sit down and put together a proper explanation.... Anyways I will get onto it shortly so stay tuned........

Thank you Neal. I will wait.