Originally Posted by Allumina (Post 5740370)

Hey Monty what plugs do I want in these motors?

Also...man that Toro sure is sooooo quiet compared to the 21-4, is it just the different exhaust?

Everythings been fantastic so far...4 tanks on each mill so far :nod:

Originally Posted by Alan D. (Post 5741307)

Hey Monty what kind of run times did you see out of the 5kT?

Originally Posted by Alan D. (Post 5741333)

Just to make sure my engine was up to snuff.
I ran 7min and still had a 1/4in of fuel in the tank on a pretty much WOT track.

Originally Posted by houston (Post 5710170)

that 2060 is alot like a 9853/41005 setup

longer round header = instantaneous bottom end and falls flat on the top very fast , best used with very top oriented pipes .

medium round header = (jammin, dynamite) the best compromise between the three and will work the best with 9886 pipe ( ya baby!)

short round header = very smooth bottom end response with excellent pull from bottom to top , best used with low end to mid range pipes .

] long square header 41005= the square headers work excellent with the low end oriented pipes such as 9853 , 9901 , 3004 , 3005 and copies of these pipes . the long header can be used with a 9886 pipe when you have lots of speed burst stretches on the track of 50 -80 feet .

medium square header = (ofna) my favorite header for low end pipes



short square header 41001 = this header can create even more mid to top pull from your low end pipe (9853) without sacrificing the linear feel of the pipe . do not use with top end pipes !



there is much more i could explain but i tried to narrow it down


hope this helps ,
monty

Originally Posted by houston (Post 5741352)

thats not too bad for a 21-5k :smile:

Originally Posted by Nitro$junkie (Post 5741695)

Originally Posted by houston (Post 5745255)

one of my very favorite pipes on that engine was the ofna 063 pipeset with the ofna header it comes with . sirio 2013 was another badass one when it needed just a "tic" more top as you would say ;)

Originally Posted by PIMP_9000 (Post 5745358)

Monty thanks for the help in getting me going in the right direction. I will be in touch again soon.the engines we talked about were them turbo plug? I would prefer turbo let me know what you think. Pudding pops all around