Originally Posted by DS Motorsport (Post 7720099)

The 2604 or the Capricorn 2662 work best.
I like the 2604 the best, the 2662 gives it a higher top speed but less bottom/mid power.

The 2630 is a useless pipe if you ask me, uses a lot of fuel and creates a lot of heat with less power as most other pipes.
If you want a nova pipe get the 2660 instead.

Originally Posted by LiL_JaSoN (Post 7728078)

for 25% nitro on a RB TJ10, you guys recommend adding a .1 or .2 shim?

i need to buy some shims - will these fit http://www.amainhobbies.com/product_...n/RB-Head-Shim

Originally Posted by Stlfc (Post 7728311)

Add .2 to run 25% also if I am not mistaken those silver shims are .3. FYI picco shims will work also.

Originally Posted by LiL_JaSoN (Post 7728358)

looking at the packet of the picture, it says they are 0.3 thanks for that.

http://www.amainhobbies.com/product_...-020mm-0008-28

this one? :S

or this - http://www.amainhobbies.com/product_.../RB-Head-Shims

it says for .21 but also fits junior 9 etc

Originally Posted by Stlfc (Post 7728662)

They made a junior 9 .21 buggy engine also so those won't work.

These are what you want:
http://www.serpentamerica.com/shop/p...6&cat=9&page=1

Originally Posted by LiL_JaSoN (Post 7728712)

only problem is.. postage is $93.. lol

but found them elsewhere

http://shopping.rcmodel.hk/product_i...10jfpk428o2625

or should i get the .15

http://shopping.rcmodel.hk/product_i...ducts_id=14708

Originally Posted by Stlfc (Post 7729665)

Well you need a total of .5 shims so what ever way you can come up with that number is not important. I always use 2-.1 shims and the stock shim when running 25% and the motors seem to like that.

Originally Posted by Speedy Gun (Post 7727466)

Can anyone tell me if the piston & sleeve, rod for a T9/10 will work in a R3?

Originally Posted by DS Motorsport (Post 7731848)

Yes, they are a direct fit.
The crankcase hasn't changed.
Only big change has been the T10RC crankshaft which is now balanced.

Originally Posted by musti72 (Post 7736004)

So Novarossi Plus 12-3SCT Piston sleeve fits on a R3? And where can I find a T9/10 piston sleeve set online? I will need a new P/S for my R3...

Originally Posted by musti72 (Post 7736004)

So Novarossi Plus 12-3SCT Piston sleeve fits on a R3? And where can I find a T9/10 piston sleeve set online? I will need a new P/S for my R3...