mine doesnt have any :( when I looked at the last pages of the manual saying what parts are in the bags, the collet pic and part # has a cover.

btw where are the screws to set the droop of the car front and rear? whats the diff between the T0129 or T0128 A,B,C (step 19)?

obviously the manual is incorrect about the parts placement but this is minor problem. I found the diff gasket with the foam bumper bag after I built the diff with a MTX2 gasket (same)

yeah...i cant find it either...the guy who pack my kit forgotten to put it for me...:mad:

also, i could find the part no. or pics showing the collet to be used in the manual...:(
i used my RR collet instead...

manti im finish with the assembly but I dont know where these parts go.

sorry Im only using a webcam

how much is the shark pipe manti?

the triangle thing goes to your mugen starter box if you have one

the one with two small round legs goes to the main chassis and it is the lower stopper for the brake

the two extra ball cap is for your rear camber link if you need a longer one. dunno about the plastic ring

oh, that plastic ring is for the belt tensioner, if you use 5x10 bearings, you dont need this ring

u wanna know in mm? any new discovery/ project?

around 45US$

i want to know in number of T

ic .. the one with 2 small legs is just replacement for the metal that I put just like the manual said.
thnx manticore ur the man:nod: later

yes yes

Brake Binding?
 

Another question I have is with the brakes, how freely should the car feel at neutral?

My car when push moves about 15cm before stopping, it does feel there is resistance though. I have sandpaped most of the brake pads off, however I don't want to go too far. I am running on a tight, small track and will therefore be replacing the one-way with a solid diff, therefore I will need brakes.

Can people tell me how they overcome the binding and how freely does their car feel.

Sami

i thought it should be the two pins instead of this plastic ?