Mugen MTX-4
#4696
Originally Posted by dienem
hey guys iam just about to get a mtx-4 is there anything i should know? how hard are they to build and are there any problems with them
Excellent choice getting the MTX4. The car goes together easily. I would suggest getting front CVD's and a thicker rear shock tower. Thats about the only problems I have heard about. Other than that the car is very easy to put together. Just take your time (cause the instructions are that great) and you shouldnt have any problems.
#4698
Originally Posted by Jo Gutierrez
come on prospec! i want to build another kit
I will try to keep it clean from then on...
#4699
Originally Posted by HarKonnenD
Is everyone just going to the 4 nowadays? I still see some guys with the 3, but I'm wondering how long will they stay with it?
Last edited by asw7576; 05-21-2006 at 01:25 PM.
#4700
BTW, I let you guys know that excessive grease on first gear one way bearing is bad thing. I made the mistake on today race and paid the price Luckily I still got third, but it was very close race between me and him.
Is it possible the main shaft steel become smaller in diameter where the first gear one way bearing sit ?
Is it possible the main shaft steel become smaller in diameter where the first gear one way bearing sit ?
#4701
Tech Fanatic
iTrader: (1)
Updated price for MTX4 from BrooklynHobbies:
http://www.brooklynhobbies.com/index...OD&ProdID=1549
It's time for ur x3 to take a break!~ (j/k)
http://www.brooklynhobbies.com/index...OD&ProdID=1549
It's time for ur x3 to take a break!~ (j/k)
#4703
Tech Fanatic
iTrader: (18)
Originally Posted by asw7576
BTW, I let you guys know that excessive grease on first gear one way bearing is bad thing. I made the mistake on today race and paid the price Luckily I still got third, but it was very close race between me and him.
Is it possible the main shaft steel become smaller in diameter where the first gear one way bearing sit ?
Is it possible the main shaft steel become smaller in diameter where the first gear one way bearing sit ?
skyline one.
#4707
Tech Elite
iTrader: (2)
Originally Posted by GrandeGixxer
Works good.
Ira, your too fast to be on here.
Ira, your too fast to be on here.
looks good though, this set up is easier to work on without needing too many of those c clips
#4708
Originally Posted by ira
Are you using the stock main shaft? I had a problem with the
skyline one.
skyline one.
#4710
Tech Elite
iTrader: (2)
Originally Posted by HarKonnenD
Are those delrin gears or something?