Serpent Cobra GT
#1096
Well done Andy and Mike. Serpent and Sweep is a great combination.
#1097
has anyone used the antiroll bar shaft with the antiroll wires?
http://www.igthobbies.com/SERPENT-SE...R-_p_3006.html
http://www.igthobbies.com/SERPENT-SE...2-_p_3012.html
http://www.igthobbies.com/SERPENT-SE...R-_p_3006.html
http://www.igthobbies.com/SERPENT-SE...2-_p_3012.html
#1098
I picked up one of the RTR cars and ran it out of the box at our weekly races last night. That car is pretty impressive out of the box. I ran it the first round in sportsman and won the heat, then ran in the open class main with it and finished second to my teamate Ty. Not bad .
#1099
Tech Addict
I picked up one of the RTR cars and ran it out of the box at our weekly races last night. That car is pretty impressive out of the box. I ran it the first round in sportsman and won the heat, then ran in the open class main with it and finished second to my teamate Ty. Not bad .
#1100
#1101
Tech Rookie
Folks just stating the facts .... NICE post and good news
#1102
Rear end vibration
Hello,
I have vibration issues on rear end
Exiting corners on throtle
I dont see any vibration if the car is on
Starterbox.
Any advice..
2 stage piston
1200 cts oil
Tried Yellow and purple springs
Thanks
I have vibration issues on rear end
Exiting corners on throtle
I dont see any vibration if the car is on
Starterbox.
Any advice..
2 stage piston
1200 cts oil
Tried Yellow and purple springs
Thanks
#1103
Try adjusting the clutch, sounds weird but sometimes if it engages too loose or even too tight this can happen. Does it do it with all of your tire sets? also check your drive pins.
#1105
#1106
#1107
I have had the same problem.
Check clutch bearings
Check two speed bearings
Check the diff' outdrives for pin wear.
check wheel balance
Aswell as the points others have noted
Regards
BM
#1108
Tech Master
iTrader: (8)
2 speed Adjustment
How far out can u go on the 2speed adjustment screws/springs before its out of spec. Stock is 5-1/2 turns out and yesterday, i finally got mine to shift pretty good at about 6- 3/4 turns out. Does this seem way to far out ? after our 3 hr enduro I took it all apart to inspect and then set it up back at stock setting and had to keep backing it off till i got it.
Also added a Buku clutch , maybe that made for having to adjust shifting some ? The thing Rips with that clutch
Also added a Buku clutch , maybe that made for having to adjust shifting some ? The thing Rips with that clutch
#1109
Tech Regular
#1110
Like 2-3 seconds and roll smooth again.
I tried my friend alpha tires and sweep (balanced) still doing it.
Thanks