Yo guys

when you place the clutch shoe in the second gear housing is it supposed to stick a little or turn freely within the housing, because I just placed the shoes in the 2nd gear housing and turned it a little and it not turning freely its sticking on something

STILL NO 710
 

well,it was delevered today but no one was home,my 710 is at post office dammit...sniff,sniff:(

also the grub screw on the other side of the gas tank, is that to be tighten all the way or what?

The 2nd speed spur housing should turn freely without any binding with the 2 speed shoes.

Page 29 (Step 9.2) of the manual describes how you should adjust the gap in between the 2nd speed spur housing and the 2 speed shoes.

You mean the grub screw that goes into the sides of the tank cap as in page 22 (Step 6.4)?

Yes, you should screw it in till the grub screw is level to the outside surface. That grub screw is meant to seal off the air pressure in the tank so that it only comes out on the other side of the brass nipple.

Re: STILL NO 710
 

What I always do is I put my delivery address as my office address if that's possible for you. That way, I always get my packages when I'm at work.

Re: STILL NO 710
 

I thought Post Office closes on Sunday?

Finished building mine and took a run on sunday. Car is extremely smooth and accelerates like it is shot out of a cannon. Pushed terribly! I think it is because I did not get the brakes properly adjusted though, really. Plus the track was so slick and I did not play with tires or anything. I had motor problems, as I had put an old Novamega that has a bad carb. So I went and got a new RB Rody 3-Port and I will test all this weekend!

Guys,

I am trying to mine a little more setup, i disconnected the frnt and rear sway bars and shocks. Then set the droop as per the setup book, when i reconnected the shocks and swaybars i measured it again and it is out? Is this normal?

SN

Fair enough.But the G4 drivers only got their cars about 3 weeks ago.So it's fair game.All used to drive MTX3, V1RR and even Impulse Pro.

We're planning to go to Kuching for the Asean Cup

One of the 710s were being driven by the country top driver.:D :D

All stock except alu wheel hexes.

In the front theres no problem, U can adjust it by using the little level at the right. Also make sure your shocks are having the same size.

I have the same problem with the rear sway bar, when connecting it, my right arm goes up 1mm. my sway bar links are the same size and the sway bar is flat (not bend)..
:confused:

Nope..Zizu Zizou

Do you have a details on this ?
venues or dates maybe?
thank you..

Yes Diesel, I run the foam class. I would love to race at Brookland, I'll try to make it up there another time though because am little tied up on the 4th with something else.

Heh heh ... I really really want to, don't you just know it :nod:

Forgot to answer you on this one ... I've tried it with a NovaRossi as well as an RB and it seems that the powerband is really good at mid-to-high range. If your track is large and flowing then this pipe is perfect especially with the RB. Its even better with the RB Rody Tuned :)

Now this does not mean that its not good for the low-end either but I find the TP04 a little better. One thing for sure, some people I know don't like the Shark in-line version, not sure why.