Hey guys ....I have a 2012 Pro Edition and wanted to know how many turns out on the 2 speed shift point you guys recommend ? Running a Picco Torque EMOD....

check yourset-up book or you can see on the web site

335531, 335521 : they are hard pressed parts, ie. you cannot replace the bearing without damaging the housing..... unless you have hard pressing machine.

You buy new ones.

Hello everyone, X-RAY wins AMERICAN Touring Car Championships.
for all race coverage go to www.rcinder.com.


you caan go to speedworld raceway facebook and rcinsider facebook for the live coverage.

Billy must have been sleepy @ 2:15am...lol. www.rcinsider.com Great write up and great job Billy

What is the differences between fuel tank 338600 and 338601.

Added internal fins, and reinforced around the spring section.

Whats the spring rates for the silver springs that come with the 2012 NT1?
Are they the progressive springs? They are the only springs xray makes in silver

im running the 2013 kit can some one point me in the right direction for a low traction setup

33/28 if I recall, and no there not the progressive ones.

Two Questions:

1. - how to replace the one way bearing bearing 335531?

2. - how to replace bearing for 2 speed gear carrier 335521?

Thanks

Already answered, http://www.rctech.net/forum/12283990-post6858.html

Thanks, apparently that's the equivalent of
Front= light purple
Rear= violet
Or could be other way around, just remember the colors

best is to replace them in a whole. Useally when the bearing is shot the retainer is also worn. But with the 2 speed carrier i`v done the heat and replace thing and it works. with the one way the forces are greater and it won`t work i think. But they last several years so maybe its only cleaning the need with some oil.