Xray NT1
#2266
I forget HongKong is the best place to buy everything.
#2268
Snowy,
I'm running an RB Matrix and I know at least another two guys that are. Although it is a tight fit they do go in without any mods.
Try having all the screws loose, fit the engine and then tighten them up. I didn't think it was going to fit either but after loosening the screws it worked.
Great combination by the way!
Good Luck.
I'm running an RB Matrix and I know at least another two guys that are. Although it is a tight fit they do go in without any mods.
Try having all the screws loose, fit the engine and then tighten them up. I didn't think it was going to fit either but after loosening the screws it worked.
Great combination by the way!
Good Luck.
#2269
Hi
I have a question... If i was to put a JLR Ret Dot into the NT1, do i need to make any changes to the collet or anyting for the clutch? And do i use the Xray collet or the one that comes with the engine?
Thank you in advance
I have a question... If i was to put a JLR Ret Dot into the NT1, do i need to make any changes to the collet or anyting for the clutch? And do i use the Xray collet or the one that comes with the engine?
Thank you in advance
#2271
Thank you for the reply... what length should the collet be then? I currently have the JLR in a 2nd hand car i bought, so i am not sure if it is the engine collet or something different.
Maybe it would be easier to install my STS into the NT1
Maybe it would be easier to install my STS into the NT1
#2273
sorry friend,have not came across this engine before,but i have friends running the matrix engine,they didnt discuz this with me and was running quite well.i heard its the same base as sirio,more alike sounds and internally similar.
#2276
I put the Red Dot in mine and used the stock collet without any problems (the Xray one was not available then). I'm not sure why Osiris had to grind his...maybe there are different types out there?
#2277
Tech Regular
Screwing them flush leaves to little space (at least, that's what happend here)
Just make sure the axle is moving freely with the brake in natural position and with as less play as possible before the brake initializes...
#2278
does the ufo 2 clutch work on the nt1???
#2279